UK Plumbers Forums | UK-specific Plumbing Advice Forum

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Questions and plumbing advice in the UK Plumbers Forums - This is the UK Plumbers Forums. Plumbing threads related to UK rules and regulations. Advice for Plumbers in the United Kingdom. Keep Gas-related advice in the Gas Engineers Forum..

Normal Threads
https://www.wickes.co.uk/STS-Construction-Board-1200-x-800-x-12mm/p/225437 Found this. Just...
Answers
1
Views
714
Hi, In the process of a new build and we have routed a MDPE pipe through a lintel in the DPC but...
Answers
7
Views
2K
C
New radiator . Not heating up as oh think it should , not very hot and has been bled. Under the...
  • Colin stewart
  • 0
  • 716
  • Latest:
  • Colin stewart
Answers
0
Views
716
Colin stewart
C
Hi all I have a mixing valve question. Should I have one fitted close to my new unvented cylinder?
Answers
9
Views
925
I moved my boiler to the loft. I think it's 22mm pipes up there but they are close together and...
Answers
4
Views
2K
Anyone had any experience with this ideal standard toilet flusher? It presses down and flushes...
Answers
17
Views
2K
Just had extension built with 1 new rad and 1 plumbed in towel rail. Since this was connected I...
Answers
8
Views
1K
B
Hi, We had all the rads replaced in the spring. They had this issue from day one but, tbh, I...
  • BobbyS
  • 1
  • 868
  • Latest:
  • Deleted member 120897
Answers
1
Views
868
Deleted member 120897
D
Hi I have attached some images of the current pipe which is cast iron and always getting...
Answers
2
Views
769
Can i use the typical clay to pvc coupling which is round on this octagonal clay pipe?
Answers
5
Views
1K
S
We had an incident of estate water pipe burst and united utility had to fix the issue for the...
Answers
7
Views
1K
D
Please advise how to restore off peak hot water
  • Didi Petkova
  • 3
  • 684
  • Latest:
  • Murdoch
Answers
3
Views
684
Murdoch
M
Hi All, I've recently submitted a meter reading to Thames Water and received a bill of 223...
Answers
7
Views
3K
Our Potterton EP2 was old and the sliders for HW/CH were loose. We couldn't get CH without the...
Answers
2
Views
991
My backyard became very wet over the past year. Today i did some digging and found this...
Answers
3
Views
962
Hi there I am trying to turn off the water in my home - have found the tap to turn it off and...
Answers
3
Views
581
J
Hi, I would be grateful for any advice regarding regulations on installing vent pipe. My...
Answers
2
Views
807
Does anyone know what this parameter on the newer viessmann 100-w (B1KF) range does ?
Answers
0
Views
525
We currently have the ground floor wet UFH and upstairs rads running from an unvented condensing...
Answers
0
Views
880
M
I tried for hours to get a round drain cover out so i cam replace it with a new one... will they...
  • Melanie
  • 1
  • 963
  • Latest:
  • Deleted member 120897
Answers
1
Views
963
Deleted member 120897
D
Hey folks! I have been trying to get my heating up and running properly but I have had some...
Answers
5
Views
1K
The situation is as follows. I have a shower enclosure which is slightly too small for the new...
Answers
0
Views
860
What parts do I need to replace this 40mm setup? I'm thinking of cutting the pipe to the right...
Answers
2
Views
615
H
Hello, we have problem again with hot water staying on and getting very hot. Looks like...
  • Howard71
  • 1
  • 725
  • Latest:
  • Deleted member 120897
Answers
1
Views
725
Deleted member 120897
D
Hello all, Have 3x windows and 2-300mm insulation in attic. I've noticed recently a wet patch...
  • foghornissue
  • 9
  • 966
  • Latest:
  • Murdoch
Answers
9
Views
966
Murdoch
M
Have any other plumbers thought of getting in to electrics? If so how have you done it/what...
Answers
20
Views
2K
RobinA
R
Hi all Totally new to this forum and hoping for some guidance. Two weeks ago we noticed a...
Answers
2
Views
1K
T
Hi everyone. We have installed a new shower kit (over the bath). Not touched the bath mixer taps...
Answers
2
Views
1K
S
Hi there, our flush valve is still raising but refusing to drop back down. Been to all the...
Answers
2
Views
890
We've been the house for just over 2 years. We've only just got around to figuring out this 'Y'...
Answers
2
Views
691
Post a New Thread / Question

New Threads

Back
Top