bath

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

bath

Recent contents Top users
  1. K

    Leaky elbow on bath drainage - I screwed up!!

    Hi all I could kick myself! I finished the drainage for my bath today but upon testing there was clearly a leak from one of the elbows just before it hits the soil pipe (see photo). I'm not happy, this was a simple joint with all the space and time but somehow I haven't applied enough solvent...
  2. K

    Connecting bath drainage to soil pipe

    Hi all, I need to connect my bath drainage to my new soil pipe. I have only one spare entry to boss into the pipe at the very bottom (see photo). As the inital entry out the wall will be on a gradient I was wondering if there was a combination of elbows I can utilise to get a 90 degree vertical...
    • kristeva
    • Thread
    • bath pipe soil soil pipe
    • Replies: 8
    • Forum: Boilers
  3. H

    How to access taps behind a P shaped shower bath

    I'm about to install a P shaped shower bath into a small bathroom. However I've noticed that with the bath in place it's not possible to reach under the bath to the pre drilled tap holes. Because of the circular shape there's also no line of sight to these either making it very hard or...
  4. S

    Dripping hot water bath taps that has a plastic cover over the 1/4 turn cartridge.

    I have a dripping hot water bath tap. I have removed the top but underneath is a plastic cap ( see picture) but the cap will not come off to get to the cartridge, and I don't want to force it in case it breaks. Anybody any ideas on how to remove it, and if it breaks where you would be able to...
  5. L

    Disconnecting a bath! How to cap off the tap supplies?

    I want to cap off the supply to my bath taps before removing the bath itself. Would I do this with a few Polyplumb stop ends? If so, is there an obvious point on each set of pipes that I should disconnect and add the stop end too, or will any work? (I'm only an amateur DIYer, but to me it...
  6. M

    Acrylic bath manufacturing standards/dimensions

    Hi all, I have been refitting my bathroom and the final piece is the bath. I have a separate shower so wasn’t looking for reinforced and decided I was happy with 5mm acrylic. As I was putting the feet on the bath I looked at the underside of the rim and noticed that the acrylic looked thin...
  7. Dan

    See the Stunning Before and After of These 6 Local Kitchen and Bath Makeovers

    Working with expert designers, these six families transformed their homes into functional and beautiful spaces. Perhaps it’s still the pandemic effect, or a side effect of the tight housing market, but the propensity to invest in one’s own home – and honor its historic integrity, too – is...
  8. A

    Bath overflow pipe

    Hello everyone. New to the forum and looking for assistance / advice. I live in a rented house with a not very co-operative landlord. I have just discovered that my bath overflow drain pipe is not connected as the flexible drain tube looks like it has been cut off at some point. After studying...
  9. drippy

    Trevi/Ideal Standard Bath & Shower Mixer A7000AA/A7100AA

    Please help me obtain a copy of the user manual for this bath and shower mixer, pictured below. I am particularly concerned about how to re-regulate the bath filler so it fills the bath to the desired level. Many thanks!
  10. C

    Best place to source low pressure bath filler taps

    I'm having a nightmare trying to find matt black wall or deck mounted bath mixer taps with 3/4 fitting that work on 0.2 bar. From tank to tap, I have around 2.4 metres, so a pressure of a little over 0.2 bar. The flow measured from the tap currently fitted is 11 litres per minute. Pretty much...
  11. F

    Rain,Bath,Greywater recycling

    Is anyone interested in a two butt rain/bathwater/greywater recycling project?
  12. E

    URGENT Bath tub drain smells - Getting blow back from drain?

    Hello All, I have an issue and hoping someone could shed some light on the problem. We have been getting a smell coming up in the bathroom, initially thought it was the toilet, but after smelling the bath tub plug hole it appears to be coming from here. I removed the P trap and very little...
  13. D

    plumber to replace bath with shower tray

    Sounds simple but I have already had a withdrawal. I live in Hull. The bathroom floor is very thick concrete because I live above a set of garages. Interested?
  14. R

    Bath/shower with no hot water

    Hello, We hade a problem with our hot water not working in one of our bathroom's (all other outlets were working) Therefore we got the Thermostatic Shower Valve changed and everything was working again. However a few days later, both hot and cold no longer works for the bath and the hot...
  15. G

    Best silicone for between metal bath and upvc wall pannels.

    Looking for silicone recommendations for sealing between a metal bath and upvc wall panels. I was going for dow 785+ but someone mentioned its no good for binding to plastic and that 785n would be better. Can anyone confirm this?
  16. B

    Hot black water coming out of bath tap in newly refurbished. Bathroom

    Hi, I hope someone can help. I’m hoping this isn’t a permanent problem. We’ve converted a gravity vented hot water system, into an unvented indirect hot water system to improve pressure in the house. The previous cylinders are in the loft now they’re in the garage next to the boiler. We...
  17. L

    Please can anybody identify this bath?

    I need to replace the bath panel on my P bath, but it came with the house and I don't know what type it is. It has a fairly small bulge for the shower end of the bath, so a lot of p bath panels wouldn't fit. I've checked the most popular bathroom places with no luck. Thanks
  18. M

    P shape bath panel??

    Out of curiosity folks. What are some solutions to fitting these panels when the floor is way out? Obviously if it’s all level there’s no issue but other than getting a chippy in 😳, what’s best? Cheers
  19. N

    How Yo Connect Water Supply To New Bath Taps

    Hi I have a 22mm hot and cold water supply to new bath. The pipes finish with compression valves. I need a 500 mm tap connector hose to connect with half inch thread on the new bath tap. All the connectors at the main plumb merchants are 22mm x 3/4 inch. No one seems able to answer question...
  20. M

    Mdf bath panel with plinth?

    Hi folks Do you guys fit your own timber panels or get a chippy in? A lad I know has fitted one of the mdf panels with the 100mm skirting trim using 2 battens either end of the bath. Customer is refusing to pay as it bows slightly when touched. Do you guys build a frame if you do it...
Back
Top