head | Page 3

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

head

Recent contents Top users
  1. K

    low water pressure shower head

    I purchased HIX 250mm Fixed Shower Head 1 month ago (here is the link to the product HIX 250mm Fixed Shower Head - Brushed Brass Finish, MP 0.5 [33250BBR] - https://tapron.co.uk/products/gold-shower-heads-33250bbr from Tapron) 1 month ago but the water pressure is very low, can someone help me...
  2. D

    I need to replace my old Danfoss head valve help appreciated

    Hi guys, my head valves of my radiators have broken teeth and need replacing. The diameter size is about 25/26 mm. The old ones are Danfoss BS6284 which are discontinued. I am aware that I could change the whole TVR cheaper but I just want to buy the heads please. Any help would be appreciated...
  3. P

    Mira electric dual head shower - Anyone know if they’re any good?

    I have a customer with an existing electric shower ask if they can have a dual head shower with a rainfall head as part of their bathroom upgrade. My initial thoughts were that electric showers aren’t powerful enough and we’d need to investigate what can be done from the gravity fed hot water...
  4. A

    Diverter head plant room

    Hello Can anyone help me identify this actuator head. It’s making noise, heat not passing through ?
  5. G

    Victorian Tap head removal

    Does anyone have any ideas how to get to the seat washer on this tap that is leaking badly at the spout. I'm assuming the gland part unscrews from the spout but I've tried this with condserable force but with no luck. I'm assuming the spindle is secured in and does not pull out. Any guidance...
  6. S

    shower head

    my shower works fine from the multi point the hot water comes from the hose and runs ok till i turn the shower off, however as soon as i fit the shower head to the hose the hot water cuts out after a minute or two then relights then cuts out again . new diaphram fitted but the problem still not...
  7. P

    3 Port Valve - Replace the whole thing or just the head? Videos included!

    Hi plumbers and DIYers I made a post about my 3-port valve a couple of weeks ago, but have finally been able to take a look and thought best to start a new one than tag on. Hope that's ok. Recap: We've had a problem whereby our boiler will only heat the radiators, even when set to hot water...
  8. D

    Help with two port valve head

    Please can someone advise, just had a two port valve head installed. When I turn heating and hot water on the valve lever automatically goes to manual. With the heating and hot water off I cant move the lever into manual
  9. C

    Water only from shower head

    Morning, I have an issue with my bath faucet. It used to work fine, but all of a sudden when I run the taps, no water comes from the main bath faucets. All water goes straight to the shower head, despite the diverter not being on. Any ideas? thanks
  10. P

    REPLACEMENT SHOWER HEAD ARM ADVICE: WILL IT SUPPORT A 300MM SQUARE HEAD

    Hello Everyone I am replacing an all in one shower arm and 200mm square showerhead a head has fallen off and I had to remove arm. I want to replace with a 300mm head like this. https://www.NoLinkingToThis/p/cooke-lewis-adjustable-ultra-slim-square-shower-head-chrome-300mm/5882t I have now been...
  11. P

    Bath mixer shower head height changes temperature

    Situation: Had a boiler system conversion. From Potterton boiler with Gledhill storage tank with on demand hot water to Veissman Combo with on demand hot water. 2 bed semi with only myself and wife living here. Unfortunately used iheat service which has no real customer service. Have had the...
  12. A

    Help with Shower head connector without removing?

    Morning, I have this old shower head in a newly acquired house, and am trying to find a replacement shower head. Doesn't need to be the same design, but just trying to make sure the connector is the same as a new one. I found an identical head online: But in one question the answer is its 7/8"...
  13. Husk24

    What type is this radiator valve head?

    Hi guys trying to install a tado trv but struggling to install it even with the supplied extra bits, I wanted to know the type or name if this valve head? Can anyone kindly help thanks
  14. B

    Rainfall round Shower head replacement advice

    Hi everyone, I have a thermostatic mixer shower and attached to it is also a hand held shower. The hand held shower has much better water pressure and flow where as the rainfall shower head is not nearly as good. Are there any shower head replacements for a rain shower head but not as big...
  15. M

    change of shower head

    hi all so, currently i have a rear feed shower arm and a rainfall head. is there any connector or elbow we could replace the arm with, that would enable us to connect a handest shower head instead?
  16. C

    Negative head pump questions

    Hi, Found some great answers here but first time posting, go easy on me please 😋. Looking to fit a salamander rp50tu shower pump to a gravity system. It's a 'universal' (negative head compatible) pump which will be going in the loft (2 story house) just below the bottom level of the cold water...
  17. W

    BBC tap head removal

    Hi, I am trying to replace the washers in a 1960's bathroom that has BBC (Barking Brassware Company) basin and matching bath taps fitted. Having difficulty in working out how to remove the tap handles that resemble a very chunky 4 pointed design. There's a small grub screw on one of the 4 sides...
  18. Scott_D

    shower suggestions? Exposed pipe with a rain head

    Can anyone suggest a thermostatic mixer shower that can be piped from above with exposed pipework but has a fixed rain head
  19. B

    Shower head query

    Hi everyone, I have a thermostatic pressure shower in my bathroom and a found flow reducing valves similar to the link provided. I would like to know what is the purpose of these and if I should pop one in the shower head as I opened the shower head and nothing was in it, the flow...
  20. S

    Broken Drayton TRV4C head

    I updated an old TRV3 many years ago by using the TRV4C conversion kit including replacing the black plastic locating ring fitted in the top of the body with the support ring in the pack. As the head has broken can this be replaced with a TRV4 head or do I need to buy another TRV4C conversion...
Back
Top