ideal logic | Page 7

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

ideal logic

Recent contents Top users
  1. L

    Ideal Logic in disguise

    Hi Guys Just after a few pointers not really done a lot of faultfinding on boilers but been too a friends who has a ProCombi Exclusive installed in his house. Which i believe is just an Ideal Logic, he realized that the pressure was dropping around 1 BAR every week. He has kept a keen eye out...
  2. R

    Ideal logic plus 24kw flame loss

    Evening all Went to this boiler today reset it then checked it with the fga gas working pressure with hob also running cleaned electrodes made sure the flue was clear emptied condie trap water pressure cleaned out the sprio filter gets home customer calls again boilers displaying same...
  3. G

    Ideal Isar pressure gauge on an Ideal Logic...

    Hi, has anyone used an Isar pressure gauge on a Logic? Spoke to my local plumbers merchant and the bloke said the local council do this when they can't source parts for the Logic. The part numbers are different but he seems to think they're compatible. Asked Ideal and they just stuck to...
  4. S

    F1 fault code on a Ideal Logic combi 24 boiler

    So a f1 fault code appeared today on my boiler and I looked in the manual which said it was a pressure problem. I reapplied the pressure so the gauge read 1.5 and then bleed the radiators. The pressure originally read 1.2 There was a lot of air in them which drained the pressure gauge close to...
    • scrappydez
    • Thread
    • boiler combi fault ideal ideal logic logic
    • Replies: 2
    • Forum: Boilers
  5. 6

    Ideal Logic 35+ Combi HW Flow Problem-Airlock?

    Basically after fitting new pvc piping to old 22mm copper there seems to be little/no flow from the hot water tap after reconnection and it appears to be brownish water for first second or so? New to the forum so HELLO :) Detail: For plumbing new bathroom I needed an extra T for hot and cold...
  6. D

    Ideal logic no hot water

    just wondered if any damage to the flow sensor could take out the pcb on an Ideal Logic. Can anyone advise please.
    • dawgas
    • Thread
    • hot water ideal ideal logic logic water
    • Replies: 5
    • Forum: Bathroom Advice
  7. C

    ideal logic heat 24 not firing

    Am in need of some advice please. My boiler stopped working 10 days ago showing error code fd (no flow), new flow sensor, pump, pcb, a power flush, 3 plumbers & £600 later we're still at fd and boiler not firing up past 4 seconds. Even speaking to ideal they're scratching their heads. Its...
  8. C

    Ideal logic / indenpent L2 fault code

    Have L2 lock out on a logic, anyone who work on these have any common causes of L2 on them doesn't even try to fire up then lock out as far as the customer says? thanks in advance :)
  9. A

    Ideal Logic gauges

    Serviced 3 Logic+'s today, two of which when the heating is running or the pump over run is on after demand, the pressure gauge needle is rattling about so much it is actually noticeable from within a 3m range from the boiler. Luckily ones in a cupboard so that drowns out the rattle, but the...
  10. C

    ideal logic heat 24 not playing ball

    Heat & hot water stopped 2 days ago, boiler flashing fd. Followed trouble shooting in manual and ordered a new water flow sensor. Was replaced today, still no blue light and still flashing fd. New plumber called, he replaced pump and told us to bleed rads and all will be fine. 5 hours later...
  11. E

    Ideal logic heat 15

    Went to service logic heat 15 today with complaint of L2 showing and having to reset to get it going . Hadn't been serviced in five years from new ... The heat exchanger and siphon were gunged up with aluminium oxide sediment , cleaned thoroughly., cleaned spark and sensor probes ,checked flow...
  12. C

    Ideal Logic Combi 35 F-1 error with pressure on gauge

    Hi all, New to the forum. Last night, while running hot water from our Logic Combi 35 boiler the front display started displaying F-1 and stopped producing any hot water. Of course this usually means low pressure, however the gauge is showing 2.5Bar. There is plenty of pressure at the hot...
  13. A

    Ideal logic gas valve

    Can the ideal logic gas valves be adjusted? Couldn't see anything in the manual. I've got one to go to that's making a baffling noise.
  14. A

    Ideal Logic + F9

    Anyone know what causes the Logic range to go to F9 fault, MI's just say PCB fault-replace PCB. Serviced a 24+ Heat today, 1 year old. Carried out the service, fired it up and ran through FGA checks etc. Tidied up and was talking to the customer and noticed the F9 showing. Wouldn't reset...
  15. A

    Ideal logic 24 hw flow terrible

    Hi guys had this boiler tonight. Hw pressure is terrible at all outlets. Cold is fine. had a bit of orangey water come out the bath taps. Stopcock has been off to change a scale reducer on mains up to boiler in the loft. Not by me. Cust is an idiot, trying to tell me where there is a...
  16. C

    Ideal logic boiler/heating problem

    Hi I'm just wondering of anyone can help. I've moved into my first flat (which I rent) two months ago and it has an Ideal Logic combi + boiler. I've had problems with getting hot water, especially in the kitchen hot tap where sometimes the boiler doesn't even light when I turn it on. When...
    • Cirrus
    • Thread
    • boiler ideal ideal logic logic
    • Replies: 1
    • Forum: Boilers
  17. W

    ideal logic heat 15

    Hi Wendy here sorry but I am very new to heating, I have an ideal logic eat 15 installed less than 2 yrs ago, I was getting f&d showing and got out th engineers, they replaced a water flow sensor but it still did not work, thay said I need to bleed the radiators and if that did not work then I...
  18. S

    Looking for a gas engineer to service an Ideal logic + 35kw - South East London SE23

    Hi - our boiler was installed almost two years ago and is due it's 2nd yearly service under the warranty. Ryan at Universal Gas Works installed this for us and has previously serviced it but due to his schedule and our location he can't do it this year and suggested I post the job to the forum...
    • SarahO
    • Thread
    • engineer gas engineer ideal ideal logic logic london service
    • Replies: 2
    • Forum: Gas Engineers Forum
  19. D

    Timer and Room Thermostat for Ideal Logic Plus 35

    Ideal Logic Plus 35 or Ideal Independent Plus 35? - both fit into the existing boiler space so which one would you recommend?. Am I right in saying that internally thiese are identical and the only difference is in the outer casings? Is the price difference worth it and if so -why? 2. Best...
  20. S

    Please Help! NO Hot Water With Ideal Logic 15 Combi Boiler

    A short while ago my heating stopped working. The engineer came out twice and said that some type of connection was not being made between some box upstairs (that only has a green or red light on it) and the temperature gauge downstairs in the hallway. He said that this meant something wasn't...
    • Sammygirl1
    • Thread
    • boiler combi combi boiler hot water ideal ideal logic logic water
    • Replies: 8
    • Forum: Boilers
Back
Top