installation | Page 10

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

installation

  1. D

    CDI30 installation questions

    Hi All this is my first post, so please be gentle! my heating system was a glowworm boiler, set up with I think and s plan system (HW and Rad return via pump, single pipe from boiler to 2 valves for control) filled through a loft tank, into the return HW side. vented tank. main reason for...
  2. T

    Installation of External Gas Combi Boiler in Tamper proof housing unit

    Good morning. In the process of buying a property with a gas combi boiler. It's currently installed in a wall mounted kitchen cabinet by the window. Would prefer to have the boiler installed on the outside wall of the kitchen to free up the cabinet space. Was advised by a builder that this may...
  3. GQuigley67

    ID from installation

    Just back from a 3 week holiday travelling around Europe and went to a Boiler service for my first job, Potterton SE boiler customer been in house 2 years first time they've had it checked, gave them the good news once I checked it out. Boiler looks at least 8 years old. ratio 0.0125 CO 1098...
  4. T

    water heater installation question

    Before I ring gas safe up to check, it it possible or should i say legal, to install a Morco D61E OF water heater a wooden shed, its basically a large 'ish' shed that's been divided into two rooms; a small kitchen(with sink) where the heater is to be located & a bathroom. Its a little washing...
  5. E

    Magnetic filter installation - need help

    Hi, Could you please help me locate the best place where I can fit Magnetic filter into my heating system? I have vented system with tanks on loft. Can I install this Filter on pipe with arrow? Cheers, Peter
  6. I

    Installation of a new cylinder in Cambridge

    Hello, I need a plumber to install a new cylinder in the next few weeks. Current cylinder is over 15 years old. Need the cylinder to be big enough to provide hot water for kitchen tap, 2 bathroom taps and a shower/bath. Currently there is no hot water pressure in the shower. The new...
  7. A

    G3 - structural survey for installation of unvented?

    You need to notify BC obviously and I understand you need one if it's going in the loft to comply with G3 but what if it's being installed on the ground floor and there are no structural issues to consider do you still need to get one done to tick the box? I overheard it being discussed and the...
  8. R

    Installation of new digital shower - hot water connection

    I have always done my own plumbing but have stopped at installing new connections to the hot water cylinder. I have just moved to a new house and looking to install a new digital shower in an ensuite bathroom. Unfortunately my plumber has let me down. The system is gravity fed. My question...
  9. D

    Heaing system installation - Midlands

    As per my other post in the main Plumbing forum - 7 bedrooms, circa 20 radiators (5 of these will be towel rads), 1 electric shower, 4 gas showers, 1 bath. I am looking for a new system boiler and unvented cylinder. Ideally, I'd like wifi control and zones.
  10. I

    Nest Thermostat Installation

    Hello all New to this forum but hoping to get some great advise. I have purchased a nest version 3 thermostat with a heat link. My boiler is a potterton suprima 40, and has what seems to be a simple 3 wire programmer. There are only 3 connections for this programmer labeled CH out, DHW on, DWH...
  11. U

    Toilet installation in the Basement

    I have a utility room in my basement that I want to convert to a bathroom. The room is at the back of the house. The only place that the soil pipe exits the house currently is from the bathroom on the first floor at the front of the house. Is it possible to route waste water from an...
  12. U

    Toilet installation in the Bathroom

    I have a utility room in my basement that I want to convert to a bathroom. The room is at the back of the house. The only place that the soil pipe exits the house currently is from the bathroom on the first floor at the front of the house. Is it possible to route waste water from an...
  13. M

    Gas fire installation quote

    Looking to have a Gazco Logic HE with a Designio 2 natural gas fire installed into existing fireplace. Anyone available in Northants to quote for this?
  14. T

    Combi Boiler Installation in Worthing

    Hello, I'm renovating a house in Worthing and have acquired a boxed new Remeha Broag Avanta Plus condensing combi boiler and flue. I need a Gas Safe registered plumber to install and commission, which will require re-route of gas pipe from mains and wireless thermostat installation. I'd also...
  15. S

    Further to pipes showing green patches - 18mths after installation

    I have now registered - but previous thread is closed therefore, as I cannot reply, I'm starting a new thread... Rckape, thank you for your prompt response, very helpful. Plumben, also thank you. Your responses make sense to me, however…. I have contacted 2 other heating installers to...
  16. S

    Pipes showing green patches - 18mths after installation

    Pipes are showing a lot of green patches, 18mths after installing a new heating system and water pipes. These pipes are in airing cupboard and by boiler. There is green around most of the joins of the pipes - ie where 2 pipes have been soldered together. Also spots and patches of green on pipes...
  17. R

    Shower booster pump installation (boost all outlets)

    hi, have a indirect hot water cylinder with hot and cold both fed from a 80 gallon cold water tank. Have recently fitted a thermostatic bath shower mixer tap as didn't want to chase walls/remove tiles to fit a dedicated shower. Both has poor flow plus the flow to basin tap is generally poor...
  18. D

    Boxing pipes after new boiler installation

    Hi, I had a Vaillant ecotec plus 418 fitted a few months back. I have finally got round to repairing the boxing for the flow and return pipes and wondering if there are any restrictions as to how close to the flue the boxing can be. The screws are accessible so it can be maintained. I have...
  19. A

    Legend Heritage Gas Fire - Installation Manual

    Afternoon all, First post (after my introduction) and looking for some assistance, if possible. We have a Living Flame Gas Fire by Legend Gas Fire Ltd. Just at the wrong time of year it has started to cut-out. To my (untrained) knowledge this is likely to be the thermocouple or pilot unit...
  20. U

    Installation and operating manual for a Fastar boiler RSQ-12YZD

    Hello there, I wonder if anyone could help please? We have mislaid the manual for this system, and cannot find anyone who will supply a copy, an email file or photocopy would be fine. Many thanks Mary
Back
Top