installation | Page 9

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

installation

Recent contents Top users
  1. J

    Urgent help needed with air vent installation

    Hi, We have an old Baxi Bermuda 552 in our kitchen diner (installed in 1989). We have recently had our window and wall taken out to install patio doors. The air vent for the boiler was removed at the same time. We need to install a new vent ASAP as I am aware that this could be quite dangerous...
  2. J

    All house water pump installation

    hi I am looking to fit a all house pump to my gravity system, I already have a pump installed for the shower, pump located at the tank floor level, but want to remove it and connect the shower feeds back into the system without the pump, I am confident on how to do this, however, once this is...
    • Jamesey1823
    • Thread
    • house installation pump water
    • Replies: 1
    • Forum: Bathroom Advice
  3. S

    6014 level 3 Gas Utilisation Installation and Maintenance or APL CCNL1 gas

    What gas training to do 6014 level 3 Gas Utilisation Installation and Maintenance or APL CCNL1 gas? Has anyone doen either of these courses? Any recommendations as to which one is best? Many thanks
  4. W

    Underfloor Heating Installation

    Hi Guys Im fitting an underfloor heating system in a conservatory and possibly into there kitchen as well. Does anyone know of a system where i could just run off the existing rad in the kitchen. Or is it back to airing cupboard with a separate flow and return. I know this is the best method as...
  5. Robert Tyrrell

    Underfloor heating installation course

    Does anyone know of a good course for UFH? I have been offered a bit of work where I am installing a new boiler (Easy enough) and they want underfloor heating installed in the new conservatory they're having built at the same time. Ideally I would like to complete the course within the next...
  6. GQuigley67

    timeclock installation tips

    evening folks got a timeclock to install, one not there just the wires, its been disconnected and thrown away, wires covered with a blank plate. One of the cables has "TC" written on it, the other "CH" I'm assuming the TC is the live feed, not sure which one is which as it is different colours...
  7. N

    new installation

    hi all 1st posting here long posting so stick with me pls replacing my thorn apollo to a wb 34cdi. going to be connected to 5 double rads and 1 towl rad, yes over powered because its going to feed a mixer shower, 14.4 lpm, had a few companys in for prices starting off with bg 3800 inc wb...
  8. O

    Shower installation - Hole in tile and small gap in casing

    Hi all, I've just had an electric shower installed but I'm unsure if I have a problem. The plumber mentioned that the pipe was on the wrong side and couldn't easily be moved so he has installed it the best he can but there is an exposed hole in the tile and also the casing hasn't quite closed...
  9. H

    Advice - is this British Gas filter installation acceptable??

    Hello - would appreciate some advice - British Gas have just installed a new boiler. I have complained about the fitment of the Spirotech filter - see images. It's physically jammed in between the cupboard and boiler casing. 1 - Do you think this is acceptable? 2 - Is it true the feed/return...
  10. D

    Third Generation Nest Heat Link installation to a Vaillant Ecotec Pro 30

    All, I know there are a lot of threads on this forum, on a number of other forums and also videos on YouTube but I have found little information on this specific install and the information I have found has been confusing and sometimes contradictory. I have just had a Vaillant Ecotec Pro 30...
  11. stani

    Boiler installation

    My son sent these pictures from someone asking for a plumber/sparks to say wether this was safe or not, I asked him to pass on the forum name and asked her to register, it appears to be a landlord Ed property. the pictures will speak a thousand worlds.
    • stani
    • Thread
    • boiler installation
    • Replies: 16
    • Forum: Boilers
  12. M

    Nest 2nd gen installation advice

    Hi all. I've just received my nest and I'm installing it now. Originally I've got a wireless receiver next to the boiler and a battery operated wireless stat. Now I assume I just take my live and neutral from the receiver and put them to the nest and the common and call wires from there to...
  13. T

    Column radiator installation - stupid question re blanking plugs

    Hi I'm halfway through replacing a rad with a new Acova Column radiator. Howerver I've taken it out of the box and it only has two out of the four of the corners with holes and trheads for valves / air vent. Both are at one end of the rad. At what I assume is the bottom, and where I'm...
  14. M

    New boiler installation - bricking up old flue

    New boiler fitted, part of the install was to brick up the old flue, prior to the job starting the plumber asked; 'Do you have matching bricks for the hole that will be left, or he can bring his own but they won't match the colour of your house bricks' My reply - 'Bring bricks anyhow, but...
    • markymanc
    • Thread
    • boiler flue installation new boiler
    • Replies: 25
    • Forum: Boilers
  15. C

    Nest installation costs and anyone local to Leicester?

    Hi all after having two faulty Salus wireless stats I have changed to a nest now . I am looking for a guide price to have it fitted by a local engineer around the Leicester area . I am 5 mins from junc 21 of the M1. many thanks
  16. J

    underfloor heating installation problem

    guys , can you assist , have had underfloor heating installed and it is becoming a nightmare as different people are involved ie underfloor people , electrician and plumber. i am far from happy with job and it is due for commissioning this week even though i have told both the plumber and ufh...
  17. A

    LPG domestic installation

    Hi all Approx 2 years ago we requested our housing association to move us out of our large family home into a small bungalow as we need level accommodation due to disability. Suddenly in the past 2 weeks one has come up which we have been offered. Our problem is this several months ago we...
  18. B

    Commercial gas installation, domestic boiler

    Alright guys? I went to a property today for a boiler breakdown, easy enough to diagnose as a faulty gas valve. Problem is, the house it pretty large, it has a 35kw combi (used as a system boiler), another 40kw conventional boiler, an andrews water heater and an aga, all connected to a U16...
    • bewsh
    • Thread
    • boiler commercial gas engineer installation
    • Replies: 14
    • Forum: Boilers
  19. C

    installation of a cyclinder

    Hi does anybody know if you can install unvented cylinder with oftec .or do you have yo have unvented cylinder ticket separate. Or does it just apply to gas .??
  20. AlexGas

    How to pressure test your bathroom installation...

    :biggrin:https://m.youtube.com/watch?v=YJTqg5NlHFI
Back
Top