kitchen | Page 8

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

kitchen

  1. S

    new kitchen designed and want to move the washing machine across one space

    Hi. I am having a new kitchen designed and installed and need some advice about whether what I wish to do would work well enough. Currently my freestanding washing machine is in the corner of my kitchen, next to an outside wall. The plumbing and standpipe are right next to it, so it all works...
  2. G

    Leaking kitchen tap

    Hi I replaced my hot and cold tap tonight cause the cold tap couldn’t turn the water of tap was just spinning. Fitted fine with no leaks. Now I have a leak coming from the middle bit where the chrome threaded ring is. Do I need to tighten the chrome threaded bit up in the middle to stop the leak...
  3. D

    Kitchen Cold tap not supplied by cold mains?

    Hi There Moved into a new build recently. Noticed that when I turn on the cold tap in the kitchen a pump in the attic seems to activate which would indicate that the cold tap in the kitchen is not fed directly by mains (however i am not a plumber so could be wrong) Prior to noticing this pump...
  4. R

    Kitchen sink overflow cover

    Hi. The cover has come off the overflow pipe on my kitchen sink. It was looking very tarnished anyway, so needs replacing. Can I buy any cover or does it have to be a certain type? I have attached a photo of the overflow in question. Many thanks Rachel
  5. E

    Kitchen sink leak

    Hi all, Noticed a leak that comes from the side drainage, not the main part of the sink. Hopefully pictures make it clear. Is this a fix I can do myself, e.g. with sealant? Or will this need new parts/plumber intervention? Thanks as always for your help. Martin.
  6. A

    Insulation installation around kitchen prior to underfloor heating

    Hi everyone. A slight conundrum im hoping to get some educated advice on from people who actually know. Ill be having the whole of my downstairs dug up in order to install insulation (none present) with a 75mm screed on top. Ill then have a wet system underfloor heating installed. My...
  7. K

    Kitchen faucet leak

    My pull down kitchen faucet seems to be leaking from the short hose that is connected to the pull down hose only when I turn on the hot water. Do I have to change the whole faucet because I don't see anyway of opening the faucet to access the hose
  8. R

    Kitchen mixer tap disaster - advice please

    I have lived at this house for over 10 years and it has been interesting keeping things working. The latest issue is a weeping kitchen mixer tap. Probably been gently weeping since I moved in but always blamed the slight damp on somthing else. Took it apart and look what I found. Standard tap...
  9. L

    How do we manage a new combi boiler moving in to the loft and relocating the kitchen so the cooker is the other side of the house? Help needed please?

    I need some advice… Our gas meter is currently in the garage conversion and runs under the stairs into the kitchen where we have the boiler. We want to do the following things: 1. Replace with a combi boiler and move to the loft. We are a semi detached house so need to the pipes run up from the...
  10. B

    smell coming from plumbing underneath my kitchen sink.

    I live in pattaya, thailand. just moved into a condo. a few days after moving in, I started smelling sewer gas coming from underneath my kitchen sink. I asked the landlord to fix it. but he has ignored me for a week now. so, I'm thinking I need to resolve this myself or move out. mind you...
  11. B

    high neck swirl monobloc tap assembly to my kitchen sink. All is well hot water comes out as a jet. Is this norm?

    I purchased and fitted a Swirl high neck monobloc assembly in my kitchen,all is well. However the hot water comes out as a jet. Is this normal?
  12. A

    Mystery open kitchen drain behind wall - need advice about plugging it

    My kitchen sink drain became blocked and, while unblocking it with a plunger and lots of water, I saw the dirty water leak from behind drywall about 6 feet away from sink. I had previously noticed a smell from the same area and dampness on the drywall. So I cut open the drywall and find an open...
  13. P

    What are the regs on commercial kitchen gas solenoid valves

    Been asked to wire up gas valve in pub kitchen and all the gas fitter has left is a stop button, when I wired many of these for a catering firm years ago there was a control box witha current sensor that worked with the fan. What are the current requirements? Is there a minimum height betwwen a...
  14. T

    Monobloc kitchen mixer 32mm back nut - spanner

    Anyone coming across these tap fixing components. I'm struggling to find a box spanner to fit. The nut is about 33-34 mm between flats. New install and as far as I can see nothing apart from a box spanner will tighten this. Unless you have the opportunity fit before installing sink.
  15. E

    Bristan separate hot/cold Kitchen Pillar Tap Washers

    hi as our separate hot tap is dripping contacted Bristan to ask what washer to get as heard that depending on date bought, washers either rubber or fibre. Bristan said that they do not supply individual washers but only complete valve assemblies. sure that I have seen Bristan washers on the...
  16. D

    Kitchen Island Drainage

    Hi, I'm planning on putting in a Kitchen Island with a sink. I've not got an easy route out to the side all where the SVP is situated. The SVP runs down the side wall and under the block and beam floor in the kitchen. Would it be possible to run a 110mm pipe from the island under the floor to...
  17. J

    Shower runs cold when kitchen sink hot is used

    Came across a tricky job last Friday.gravity fed vented hot water cylinder that is pumped via twin impeller pump.also cold from tank is pumped with same pump.pump is upstairs.feed for bar mixer shower pipes go up into loft and drop down into the shower area.cylinder up stairs.would shower run...
  18. R

    Kitchen drainage design - Please help with constructive critique and advice

    Hi. DIY guy here, not a plumber of any experience. I would be grateful for constructive critique of the drainage design presented by this diagram, accompanied by the following notes and questions: 1) On the left is dishwasher, on the right is washing machine. Purple lines represent standard...
  19. T

    Help locating a rectangular waste trap for kitchen sink?

    Hi all, I am hoping someone can advise on this.....bought a 1.5 bowl sink a while ago from B&Q but never got around to fitting it. Now decided to fit it in my utility room but upon having a look at it the smaller of the two bowls appears to have a rectangular slotted waste exit in the bottom as...
  20. V

    Fitting Franke Fuji kitchen tap

    I am going to be fitting a Franke Fuji tap at my daughter’s. The tap comes with the hot and cold flexible tails, the hot has a standard nut and rubber washer on the end for connecting to a male compression fitting but the cold has a different end ( I think because it has a non return valve...
Back
Top