Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

pipe

  1. D

    Wall mounted toilet problem with offset soil pipe.

    Hi guys, I've had a search and couldn't find anything related. Installing a wall mounted toilet, unfortunately didn't know this when I put the soil pipe in position. The supplied fitting is now approximately 130mm offset from the vertical connection. Any ideas? (amateur obviously!) Wondered...
  2. G

    Flow / return pipe layout - is this sensible?

    Hello folks I've moved into a property last month and started to note things that may need looking at. Some of the radiators on the ground floor aren't getting very hot, I've had a few passes of balancing to no avail, In light of the above, I took a look down in the subfloor yesterday to take...
  3. A

    Soil pipe connection?

    Fitting a new toilet onto this old cast soil pipe that only fits in about 2inches. It's coming through the wall at an angle and can't be changed because of an extension below. The new pan connector keeps dripping on a full flush any ideas on a solution other than silocone which the old one had...
    • Azza41
    • Thread
    • connection pipe soil soil pipe
    • Replies: 6
    • Forum: Boilers
  4. D

    Soldering poorly fitting joint - pipe not round, good fill, how?

    Hi, Short version: I have about 4" of pipe sticking out of a concrete floor in a cupboard. It makes a 45-degree bend as it exists (bent, not with elbows), the last cm before the open end is pretty much straight, but as a result of the bend it is not perfectly round. I mean it is pretty much...
  5. T

    Distance between cold pipe cross over hot

    Hello I need to cross over an existing copper hot water pipe with a cold 15mm mains copper pipe. Is there a standard I need to adhere to in terms of clearance?
  6. M

    Flexi pipes vs copper pipe

    How safe are flexi pipes my toilet cistern has one it was changed about a year ago when the toilet was removed for some work to the bathroom floor. However would it be better if replaced with copper pipe. What is the life time of flexi pipes, has any one had experience of them failing.
  7. A

    External Pipe - what purpose and is replacement necessary?

    During November we have to replace a corroded cast soil pipe on the exterior wall of the 1st and 2nd floors of our 1930’s building. Fine. However, it also has a smaller diameter pipe running beside it up the full height. It appears out of the wall, level with the first floor toilet, runs up the...
  8. R

    Coventry - groundwork pipe work needed

    I will need: install new 100mm pvc pipe work, 90-degree bend for new W/C install new 100mm pvc pipe work, 90-degree bend with new gully pot at rear of new extension for sink waste clean water pipe carry out 2 x Lead connections with a new T section No excavation needed, all is digged out.
  9. T

    Identifying waste pipe type

    How can you tell if a white 30 or 40mm waste pipe is pvc or abs?
  10. A

    Compression fitting loose on the pipe

    Hi, I am replacing a leaking push fit flexi tap connector under the bath with a compression fitting flexi. The problem is that the old pipe seems to be slightly smaller than 22 mm compression fitting and when I tighten the compression nut the whole fitting is easily sliding off the pipe and...
  11. Sannie

    Soil Pipe Connection

    What size coupler do I need to connect soil pipe to main drain - please see photos
    • Sannie
    • Thread
    • connection pipe soil soil pipe
    • Replies: 1
    • Forum: Boilers
  12. W

    Can I have single zone central heating when pipe installed for 2 zone?

    A bit of clarification - I have extended a 3 bedroom semi detached and at the time central heating pipes were going in I told the plumber could I have 2 zones - one for bedrooms upstairs and another for the living areas downstairs. Now the plastering has been finished and I am costing the combi...
  13. M

    Pipe fittings type for mixer tap

    Hello, I need some advise, will greatly appreciate if someone can help. My mixer tap is leaking from base want to renew it. However the tap cold/hot water feed is connected via connectors/fittings as shown in attached picture. Can anyone please advise how to disconnect tap from these fittings as...
  14. S

    Old Hunter soil pipe socket O-ring woes :(

    Hi all, Have got an old 60/70s PVC soil stack, the Toilet is going into a Hunter branded socket which has an old O-ring design (quite flat with 3 or 4 ribs on it). It's painted in a fetching pink/purple colour in the photo. Tried to revive it with some grease before inserting a short length of...
  15. I

    Thermal Store Heating Up Cold Feed Pipe

    Hello, I have just installed a vented McDonald 250L thermal store, it is for multi fuel but currently just connected to a standard oil boiler in the garage which is fully pumped to the TS, the system has two pumps both basic 3speed Grunfoss, one on the boiler return and the other on the CH flow...
  16. OneTwo

    Mystery Black Undergound Pipe Leak Repair Advice

    Hi All After having pooling water on my drive, I dug down around to find: Black pipe poly/plastic dug 450mm deep spraying water at mains pressure from small hole/crack The outside of pipe (measured with veneer caliper) at 23.5mm Pipe Runs under drive, along side of property and looks to go...
  17. DIYGraemeB24

    Toilet inlet pipe leak

    Afternoon all, It appears my toilet inlet pipe has developed a leak at on of the top 2 joints (between plastic pipe into toilet and between copper pipe with isolator screw) I'll attach pic. Just wondering what the fitting is that I need. Thanks, G
  18. Zoe100

    Waste pipe problems in new build

    Hi could anyone give advice please ? I went to look at a new build for sale they are apartments/ one house on top of another all properties will be privately owned by individual buyers, a guy on-site pointed out that the plumbing is wrong on the properties as a perspective buyer I’d like to know...
  19. M

    Blocked shower waste pipe in ceiling void, solutions?

    Hi folks As mentioned in the title, are there any solutions to the problem, other than cutting an access to waste pipe and cutting pipe at nearest elbow or tee? Hair has been removed as much as possible and a drain cleaner used but still very slow to drain. I’m not keen on strong chemicals...
  20. A

    Connecting To Old 3/4" Copper Pipe That's Smaller Than Usual

    Hi, I'm trying to connect 3/4" copper to 22mm copper in an old house. However it appears that the 3/4" is actually slightly smaller (measured at 21.1mm) than it normally is. This means I've been unable to use the special 3/4 to 22mm compression fittings as the olive is just too loose...

We recommend City Plumbing Supplies, BES, and Plumbing Superstore for all plumbing supplies.

Back
Top