power | Page 4

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

power

Recent contents Top users
  1. P

    Delay in power shower.

    I had a new power shower pump installed about two years ago as the previous one was leaking. For quite some time the pump kicked in immediately the tap was turned on. However recently there is a delay of up to three seconds. Is there anything I can do about this?
  2. DripsnDropsBognor

    Power flush advice needed

    Hello, Been out to one of my ladies and she has filled her CH system with a leak sealer... Over christmas as she had a pin hole in towel rail. Called me out for other bits and mentioned this I went in to loft and looked on F&E and it's is only about an inch over tank connector and has...
  3. eagleeye

    Worcester filter power flush adaptor

    Does anyone know if you can buy an adaptor to fit on the unions of the worcester filter so you can connect magnaclense power flush machine connections ?
  4. H

    Overflow into small f&e tank - coil broken or power flushing needed - or both

    water overflows into small f&e tank, about one bucket every 30 mins, is slightly rusty colored, have traditional system, hw cylinder 30+ years old, pumped heating, vented system, radiators also mostly quite old (30+ years), heating works well, NOW MY PROBLEM - one plumber says there is a split...
    • helon
    • Thread
    • overflow power tank
    • Replies: 6
    • Forum: Boilers
  5. DIY newbie

    Mira Event Power Shower hot feed stopped working

    I have a Mira Event XS Thermostatic power shower which I installed about a year ago. Today it has stopped working properly, as if it is only receiving water from the cold feed. The pump is working and water is coming out with good pressure when the thermostatic control is on cold. As soon as I...
  6. F

    Reduce the power of gas burner by lowering the motor rpm

    Hey guys ! We have a big industrial boiler (installed to provide heating for 80 apartments) which comes with a natural gas burner. The burner has a 4KW 3000RPM motor which provides the air flow to the burner, is it possible to replace the motor with a 1500RPM motor to reduce the heat output of...
  7. J

    Ballpark charge for power flushing 10 rads, system boiler OV

    Hi all, Would someone give me an idea of what you'd charge to power flush a 10 rad system (I'll hire machine from BSS). 15mm pipework (NOT 8 or 10) Glow-worm Flexicom 24hx boiler Open vent. Cheers Jim
  8. Alan Wright

    6 Shower Power Boosters Give Away Competition

    A plumbing magazine is showcasing ShowerPowerBooster and they are also running a competition to win one of three SP22S ShowerPowerBoosters A SP22S is two fully automatic ShowerPowerBoosters retailing at £200 each (6 pumps) Entry is free! Just Click on the link below to enter the competition...
  9. OffshoreGas

    Power flush vs passive filter

    In 95% of instances the much cheaper/simpler Magnacleanse type filters seem to be really effective. You obviously need a working circulating pump but has anyone used one where a boiler couldn't generate hot water? Do people still buy powered units? I had planned to buy one but haven't really...
  10. D

    Shower Power Booster Pump

    Anyone fitted one of these small booster pumps? I'm fitting one on Sunday and they are supposed to give a minimum 1 bar boost. They can also be used on cold mains supplies and feeds from boilers. showerpowerbooster.co.uk
  11. Bettyboo

    Cleaning rads without power flushing

    Evening all My rads are quite old (30 yearsish) they are the standard single panel rads. The ones downstairs have large cold patches at the bottom when the heating is on. I want to keep them as I do not want anything deeper to block vital space and because I do not want to change the pipe...
  12. G

    Boiler wont ignite after power off

    I replaced a couple of TRVs earlier, and prior to starting I powered off the boiler (a Main Heat 15). Boiler is 7 months old, and never been isolated from the mains before today. Once all the rads were bled, went to power on the boiler and now the pilot won't ignite. And the reset button...
    • gavc
    • Thread
    • boiler power
    • Replies: 30
    • Forum: Boilers
  13. S

    gravity or booster or power shower

    Hi all, For new affordable 2 storey 100m2 3 bedroom semi detached with air to water heat pump and system mixing valve, which should I go with: Option 1: gravity domestic water with pumped shower (mira vigor) Option 2: whole house / stuart turner monsoon - which model Option 3: whole house /...
  14. O

    No power to heating pump.

    Hi guys needed some advice had to change a TRV on a radiator so drained down the system 12 rads altogether there is a unvented cylinder and heat only boiler i refilled the system again bled the air from all the radiators and air release valves by the cylinder all fine but there seem to be no...
  15. CorgiDirect

    Kamco and Norstrom Power Flush Machines From CORGI direct

    Kamco and Norstrom Power Flush Machines From CORGI direct VIEW HERE Professional, Versatile and Easy to Use. Professional Products For Professional Engineers
  16. CorgiDirect

    Excellent Prices on Kamco Power Flush Machines

    https://www.corgi-direct.com/kamco-products-17951-0000 …
  17. D

    Power flush prices average

    What's an average price not premium as in London for a standard powerflush of up to 10 rads in a domestic property? I have a chance of the kit and wondering if its worth the money
  18. NODDYNODSVILLE

    Power flue to Balanced flue

    Further to my post earlier today, a change of plan. Is it possible to change a power flue fire with no chimney to a Balanced flue fire? and if so, what is involved
  19. J

    Power flushing and drainage

    hello everyone What level have you got to be in order to carry out power flushing have you got to be level 3 ? And also interested in unblocking drains what is the best route to go ?
  20. T

    Had a Power Flush now looking for a bit of advice

    Hi all, This is in no way a blame thread for the recent work I have had done as the guys were top notch, just looking for a bit of advice on a few puzzling questions I have since. I had a power flush done as two of my 12 radiators were not getting hot in anyway even though the flow pipes were...
Back
Top