Okay, so I tested a way to play FIXRADIO when you wanted to play it, but it took over the world and started to breed and everything! - So I've reconfigured it and it's just a link in the menu now on the Forums tab. So here it is on Desktop/Laptop It's in the grey sub-menu.
You'll find it in...
New build job, 4 zones, unvented cylinder and boiler on top 3rd floor, cold main in 28mm comes up through voids were it could be picking up heat from sec return and heating circs. These voids are well insulated.
The builder is saying the pipes should have been lagged everywhere to stop heat...
Hello,
I am in South Devon and have a Daikin monobloc air source heat pump with HW cylinder which provides CH & HW. Currently CH off and just supplying HW. Once a week (SAT) the system heats up to 70c for sterlistion etc. It has been doing this in almost silence for 3 1/2 years until today...
Water is constantly running through the cold pipe that leads directly from my stop tap through a few meters of pipe along and then upstairs. I can clearly hear it (and so can the rest of the family)and feel the vibration caused by the flow of water through the pipe. When I turn the stop-cock off...
Has anyone done this?
I need to get a supply from the kitchen to an unvented cylinder on the 1st floor. Only way really is out under the sink, around the sid of the building and up the wall into the airing cupboard.
What's the easiest way to run this pipe in a waste pipe insulated?
Cheers
Hi
We have a logic system 24 boiler. I turned the boiler ofr for 2 weeks while away. Ever since then the fan is running constantly. Even when the burner is off or the programmer is set to off the fan is running. The code on the display is 'c' which i think means that the boiler thinks there is...
Our bath and en-suite shower is fed from a cold water tank in the loft. My kids have decided they like the shower but stay in it a long time. This causes the tank to empty and airlock the shower pump. I then have to the disconnect and bleed the the cold water feed.
I there a way to make the...
I have an Ideal Classic FF230-280 Boiler on a ‘closed’ system. For some unknown reason the main circulating pump now never shuts off, even if the hot water and central heating are not called for on the timer. The only way to turn it off is to actually turn the main switch off on the wall. I...
I have a problem with my shower - it started dropping in temperature to where even on the hottest setting it now runs lukewarm at best. Previously happened about 3 months ago and was then taken apart and adjusted the flow from the inside which seemed to solve the problem for a while, albeit I...
Hi,
Our heating system has started whistling very loudly when the shower is being used.
If I run a cold tap, the whistle stops immediately.
If I run a hot tap, the pitch of the whistle changes.
The noise is not coming from the boiler (Ideal Icos) which is in the kitchen, it is coming from...
Hi I have an issue ( maybe 2 ) the toilet keeps running into bowl through the internal over flow also its running out the top by the arm on the left ( see pic ) if you lift the arm up it stops coming out of it but continues to trickle into the bowl below I've had a look online and its...
Hi all,
This is my first post, had no option but ask more experienced people before making expensive mistake.
I would like to put my WM on opposite side of a sink where waste pipe goes at present. I will have enough space to put tall pipe and p trap behind WM. I am planning to use 40mm pipe...
Hi
We have the following problem when we run the hot water tap on our bath. Basically it starts to come out hot then after a few minutes it goes lukewarm and I'm not sure why. When I try the hot water tap on the kitchen sink it comes through a lot hotter and there are no problems with running...
Hi there, can anyone give me any advice?
We have a Saniflo system in our understairs loo.
The saniflo itself is working fine, but there is a constant trickle of water going into the loo bowl, hence the saniflo comes on every ten mins or so to pump the extra water away.
I have no knowledge of...
Hot water is trickling from the header tank overflow pipe only when the CH is running. It is a dual system (CH or hot water with motorised valves) and no drip occurs when only heating the hot water. No drips either when boiler is off so the ball valve is OK.
Now my small 2 up 2 down house only...
Hi all.
Before I begin, im talking about older ‘on/off’ fans on atmospheric burners. I am not talking about the newer variable speed fans with zero rated governors on condensing boilers.
All I’m wondering is, can an on/off fan run slowly when supplied with 240vac? Would this cause higher...
I live in a rented house with a Saniflo system in the upstairs bathroom. Currently we have been having some problems with the upstairs toilet running all the time and reflushing itself, so we've turned off the water to it. However, the Saniflo pump is still turning on, every 9 minutes. Does...
Main Combi 30 HE when cold, set central heating to on, boiler fires and flames for a few seconds, flame goes out but pump continues to run.
If I turn hot water on then HW operates and feeds through, stop HW and pump still running.
Is this likely to be a pump issue or a PCB issue? Was working...
Over the last few days we are having problems with the boiler cutting out after a few minutes.
Hot water seems to be fine (although it may be taking a bit longer than normal to heat up), and the flames are all lit. They remain lit whilst the hot water is running (which is correct).
The...