Hi, I have fitted an electric shower, teed off the toilet cold feed (Mains)
The pressure for the shower is very very poor just dribbling out.
Pressure is fine
Lpm is fine
Fitted loads like this before and never had a problem
Any suggestions ?
Hi all
I had a new bathroom fitted about 4 months ago and all was fine until about a week ago.
But now when I turn the lever to run the rain head there is a 30s delay until water starts coming out , very slowly then builds up to the flow I would expect. ( I can hear water running and filling up...
Please help me obtain a copy of the user manual for this bath and shower mixer, pictured below.
I am particularly concerned about how to re-regulate the bath filler so it fills the bath to the desired level.
Many thanks!
This is driving me bonkers!
I have a Jaquar shower mixer unit - which has started to leak from the diverter cartridge. I think it's an early Florentine model circa 2006 though not 100% sure.
I've removed the faceplate, unscrewed the chrome collar - and now want to extract the diverter...
I done a straight change from a thermostatic shower to a new mira atom shower,when I run the shower in an upstairs ensuite it runs hot for a few seconds then goes back luke warm,I have a combi boiler,any advice please??.
Hello. My mixer shower (non-electric) recently started running luke warm. I know this can happen at this time of year over winter but I've been in the property over 10 years and it's never been this bad before. The combi boiler was checked and is ok. The hot water from taps is uneffected and...
Please see attached pic. . . . I would like to replace the drain cover in my ensuite shower. Also, I am hoping, if possible, to replace the top part without taking the shower basin out (is that possible)? How / what with?
Hi All
As you can see from the attached pix, the flow control knob on my Bristan shower has broken. It was installed before I bought the house (possibly between 2015 and 2017) but I've no idea what model it is. Firstly, can anyone help me to identify it to see if I can get a replacement knob...
I have holes in the wall of my shower enclosure. Down low at the open corner, between the quartz wall and the solid pan. Same at each end of the shower. They are obviously intentional.
But they seem stupid to me. Just a hole where water can intrude thru the quartz wall to whatever is behind...
Hoping someone can please help. I have an intermittent fault with my electric hot water. I have an older style electric hot water service that heats on controlled load over night. The large tank is in roof space of 60s built villa unit. Every few mornings, no hot water will come out of...
We have a gravity fed hot water system in our the house we have just recently moved into. It works fine with the downstairs shower, however we are about to upgrade the upstairs bathroom and are considering installing a shower bath. My concern is that although there is more than sufficient...
Strange one.
Stuart Turner Showermate, supplied by customer, fitted March last year.
All was well until August when they contacted me to say there was an issue with it pulsing when the shower is off.
I don't believe in coincidence, but at the same time as the issue arose they were having an...
Hi all
I really need some help or advise…..
Back story…..
Some years ago my dad had an extension to his house which included a newly built downstairs shower room. Recently he had this downstairs shower room re-fitted/decorated. Quite a simple set up consisting of a sink, toilet and shower...
Hi
I had to remove the glass panels from this quadrant shower cubicle and I'm struggling to get one of the screens back in place properly. The small glass panel is supposed to slide into the wall channel, and some holes in the side of the channel (inside the cubicle) should align with some...
Hello
I need to replace my Grohe Geotherm shower cubicle mounted control unit.
Its around 17 years old but replacements seem to be available
The main hot / cold water control unit is in the loft, I think its working ok
How do I get the replacement cubicle control to connect to the loft unit...
Hello, I am in the process of replacing an electric shower for a customer. I’ve come across some equipotential bonding within the shower and was just wondering why this is there?
Can it be removed or does it have to stay?
Thanks
I have just had a boiler, hot water tank and power shower pump replaced on advice by my plumber. I have two separate boilers, heat/hotwater systems in the house. This boiler was replaced by a combi boiler as it only heats the lounge and master bed and provides hot water to en-suite bathroom and...
Hi, I need some help on this shower drain installation. I’m about to install a corner shower kit in my basement bathroom. But I just found out the shower drain is actually extruded from the bottom of the shower base and I have concrete floor with the drain pipe rough in. I have the drain pipe...