Good or bad idea - would you like it and be Interested in?

[ShaunCorbs]

It's all to spec so dont worry mate. Worry about your own installs

Trust me I do now did I put that test nipple back in

 

[Old Account]

All I’m trying to do is keep peace. You seem intent on arguing the toss at every opportunity even when as above you have proof in black and white. I have neither insulted anyone’s methods or said that I know better but in this instance all I’ve seen is you charging customers a “quality” rate so that you can use press fit rather than delivering the install that the customer has paid for ie a complete, safe one. I have not commented on the pressfit tee which you seem adamant you are going to ignore. Can you not see how ridiculous it is to brasso off the yellow indicator as the next engineer cannot tell if the fitting is suitable. That’s the idea of it. I would also draw your attention to the fact that you wanted this thread and all it seems to be is look at rons crimping and shiny pipework. Seriously some substance and an objectionable view to constructive criticism would make so much more sense.

I agree with a few points.
I will leave it as it is. If you want you can close this thread as I'm not going to upload anything anymore. Have good evening

 

[king of pipes]

Ron can I step in as peace maker you are digging a big hole here mate please don't jump in , Harvest and the other engineers are only trying to help you out it may come across as negative criticism but be assured we know what's right and what's wrong , posting pictures of your work on here leaves you wide open to criticism I know this from past experiences but please don't see it as us ganging up on you, we as gas engineers have a duty to ensure that life and property is protected If there's a issue regarding the fittings you have used and I am not saying there is ! please , please address the problem and if not and your 100 per cent sure that your install Meets all the gas regulations then that's the end of it . Regards kop

 

[Millsy 82]

Trust me I do now did I put that test nipple back in

Mines always did I put that fga cap back on?

It then goes

Oh hello my dear I think I left a screwdriver on top of your boiler can I have a look? Ffs a 15 mile drive just to see the cap where it should be! Pull screwdriver out my pocket here it is. Walk out muttering.

 

[Riley]

Mines always did I put that fga cap back on?

It then goes

Oh hello my dear I think I left a screwdriver on top of your boiler can I have a look? Ffs a 15 mile drive just to see the cap where it should be! Pull screwdriver out my pocket here it is. Walk out muttering.

Been there

 

[ShaunCorbs]

Yep aswell

 

[Harvest Fields]

Dito

 

[Old Account]

Ron can I step in as peace maker you are digging a big hole here mate please don't jump in , Harvest and the other engineers are only trying to help you out it may come across as negative criticism but be assured we know what's right and what's wrong , posting pictures of your work on here leaves you wide open to criticism I know this from past experiences but please don't see it as us ganging up on you, we as gas engineers have a duty to ensure that life and property is protected If there's a issue regarding the fittings you have used and I am not saying there is ! please , please address the problem and if not and your 100 per cent sure that your install Meets all the gas regulations then that's the end of it . Regards kop

Appreciate what you are saying and agree with you. I definitely installed the right fittings with the right rubbers and have nothing to worry at all. It's better not to upload anything so it won't cause any problems next time. I appreciate your step in and I'm glad we finished that subject now.

 

[Stigster]

That went well...