General DIY Plumbing Forum | Pro & DIY - | Page 11 | - Plumbing Advice Forum > PlumbersForums.net

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Questions and plumbing advice in the General DIY Plumbing Forum - Ask DIY related questions in this forum.

Normal Threads
Hi All Newbie so please bear with. We are selling our old house - built 1880. The purchaser has...
Answers
5
Views
1K
Hi I am new to this forum and would like some advice on fitting a vr33 open therm module on a...
  • boxer01
  • 1
  • 2K
  • Latest:
  • Deleted member 120897
Answers
1
Views
2K
Deleted member 120897
D
What’s the correct way to replace a (jammed and leaking) stop-cock in an old and corroded ½...
Answers
3
Views
1K
Hi I wanted to change the washers in the taps in my downstairs cloakroom. Have got as far as...
Answers
4
Views
915
Hi I fitted a bath/shower 12 years ago and a few months ago it developed a leak. It was...
Answers
16
Views
2K
J
Hi Everyone, I'm looking for a little advice so I can try and save a bit of money this winter...
Answers
5
Views
1K
Hi Everyone, (not sure if my last post worked so apologies if this is a duplicate). I have an...
Answers
1
Views
783
B
Can the return pipe in a domestic hot water recirculating loop be connected to the cold feed to...
Answers
1
Views
838
Hi, first post here and am after some advice please. I'm having solar panels fitted in the next...
Answers
11
Views
2K
Hi all I’ve just joined the site as I find myself searching for answers to heating questions and...
Answers
0
Views
930
Yes I know is a bit basic the header but have been milling this over for ages. Needs doing now...
Answers
13
Views
2K
C
Advice needed on replacing stopcock. I can’t tell what sort of pipe the mains is or how it’s...
Answers
2
Views
1K
Help needed for a DIY-er. I lifted my floorboard one night at 2am after a month of not knowing...
  • judebea
  • 4
  • 1K
  • Latest:
  • Deleted member 120897
Answers
4
Views
1K
Deleted member 120897
D
Hi all, I have a problem. I have replaced the pan connector from the toilet to the waste pipe...
Answers
5
Views
2K
The en-suite sink waste pipe gets clogged up every few years with gunk (tootpaste, soap, etc)...
Answers
4
Views
1K
Hi, I'm doing an automatic irrigation project with Arduino, which is connected to a solenoid...
Answers
3
Views
894
J
I've got a Worcester Bosch Greenstar 30Si combi boiler and I'm trying to replace the room...
Answers
1
Views
1K
Hi all The valve on this pipe (blue) is broken. We are moving out soon and I need the right cap...
Answers
4
Views
927
9-21-22 Hi All: I have always appreciated your comments and troubleshooting recommendations...
Answers
0
Views
755
P
Hi, I have a dry blue plastic water pipe emerging in my detached garage. I have no idea...
Answers
3
Views
1K
N
Hi all, I have a mechanical timer (5 wire not including ground) by the boiler for heating &...
Answers
4
Views
1K
Hi all, Would value your input. I have recently replaced a boiler with an airsource heat...
Answers
8
Views
2K
How can you fix a clogged pipe that is half way inside the wall? Should i call the plumber?
Answers
4
Views
1K
Hi all, trying to replace a Victorian mixer tap head for bath as old one getting stiff. I've got...
Answers
5
Views
2K
Just replaced taps on bath so kids can get a shower in bath as well ,worked fine to started with...
Answers
10
Views
1K
H
I have a gas boiler in the kitchen which heats the water to the upstairs immersion heater/tank...
Answers
1
Views
801
R
Help. This is the second time the fibre washer on the ball valve inlet has split and flooded the...
Answers
1
Views
594
Just looking for some advice, I have just fitted a new kitchen sink and both water pressures are...
Answers
8
Views
1K
I have just had a new kitchen sink installed, and the plumber filled it to the top and told me...
Answers
4
Views
710
Post a New Thread / Question

New Threads

Back
Top