Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the General DIY Plumbing Forum - Ask DIY related questions in this forum.
Normal Threads
I am trying to locate a Boiler thermostat sensor for an Ideal Classic FF370.Not having much...
Hi All,
Thanks for your time.
Planning a complete house refurb, where the...
Contractor sub (who evidently was not a plumber) installed my new single kitchen sink and...
Easi Heat 25Ci. plus. Runs well and no codes on panel. Responds to DHW as it should. Same for...
Hello Everyone,
I've just taken over a property that I lived in with a relative, following his...
Hi, trying to remove copper pipe from sprinkler back flow. Used blow torch to soften solder. Did...
- Bob Hacker
- 1
- 975
- Latest:
- gmartine
Replacing bathroom towel radiator, while I‘m at it was going to change the valves for new ones...
I have an older Geberit, installed in 2009 (see photo). All the videos that I can find are about...
Hi all,
I would appreciate some help - I have an outdoor tap that leaks around the spindle...
- PaulP123
- 2
- 872
- Latest:
- fourtytwo
Hi,
A bit of background first I have a air source heat pump, downstairs is all underfloor...
- michaelsage
- 10
- 2K
- Latest:
- michaelsage
I purchased a SharkBite ice maker connection kit. The kit came with an adapter to connect 1/4"...
I have moved into a property with a Gledhill SysteMate 2000 and not much clue as to how it...
I'm needing to replace a Drayton Mid Position valve Actuator, code MA1. The failed one is 3-wire...
There is a small area of discolouration on the kitchen ceiling beneath where the bath is...
Hello, we just moved into a house in the Netherlands and are struggling to fit our washing...
When I disconnected my natural gas cooktop this part was split in two. I have been to big box...
- Blumounter
- 4
- 691
- Latest:
- Blumounter
I have a freestanding bath with claw feet. The overflow pipe, low level u bend and waste pipe...
I have a freestanding bath with claw feet, the overflow, shallow waste and outlet are all...
- RoyWin
- 1
- 1K
- Latest:
- ShaunCorbs
I would like to fit a full bore quarter turn valve that takes 25mm MDPE on the inlet and 22mm...
Hi, seeking some advice on a Rayburn and control of hot water.
Leaving out a very long story...
- ThePhoenix
- 13
- 7K
- Latest:
- ThePhoenix
Hello all, I have an upstairs bathroom with a Triton electric shower that reduces to a freezing...
I have a draft Idea to connect water level control valve in series with ram pump . This setup...
- nvneplumber
- 2
- 750
- Latest:
- nvneplumber
Just had a lovely Viessmann 222-F installed along with a HUGE 5.5kw triple panel radiator...
Hi all,
I'm new to this site and have basic knowledge of plumbing.
I'm trying to fit a water...
- benlondon2022
- 2
- 1K
- Latest:
- benlondon2022
Evening all.. can anyone help me please?? :) today I cut & reconnected both the hot and cold...
Hi Guys, I have discovered leak from some safety outside my house and have no idea what it...
Hi all,
I was hoping someone can guide me to install the RHS42 water softener. I am...
- g3lo18
- 5
- 1K
- Latest:
- ShaunCorbs
Hi all,
Just had a column radiator fitted with an ENZO TRV valve (non bi-directional) on the...
Got a leak on this valve but can't nail what it's called.
Could anyone please help?
Best,
Neil.
I have a bathroom basin that had a flexible waste pipe leading from the sink into a fixed waste...
- DIYAlex
- 1
- 936
- Latest:
- Ric2013
New Threads
-
Vaillant echTEC Plus 838H over pressurisingHello. Not to long ago I took off a radiator...
- Started by lee2lee
- Replies: 0
-
-
Issue replacing 22mm pipe on central heatingHi all I was hoping to make good this corner...
- Started by kristeva
- Replies: 4
-
-
Inspection chamber leakWould someone be able to advise please. I’ve...- Started by BobThomas
- Replies: 8
-
Aliddin easyfit isolator, Anyone with a bad experience of these?Hi all, thinking of fitting the said isolator...
- Started by Barry
- Replies: 2
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 2
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 1
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 9
-
-
Boss your bathroom - Join the Tile High ClubTrade Account Victorian Plumbing 10% off for...- Started by Dan
- Replies: 0