Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the Plumbing Tools - .
Normal Threads
as title says - what is your most used or useful tool?
ta muchly
Hi
Is the a special tool to tighten and loosen this drain fitted to a bath?
All the...
Hello
I'm new to the forum and to the plumbing world but I start my course in September and in...
Not long until I start my new job, I have the majority of tools that I think I need but as I do...
Worth plugging Tradetiler Home page - He's a tool sponsor from our tiling forum, has some really...
- Dan
- 2
- 1K
- Latest:
- Deleted member 7121
Do you guys actually use these? Or just use the brushes you have on van. I see the junior has a...
Bosch GBH professional SDS drill 240v used but in good condition
Dewalt twin pack drill &...
hey, i am looking to buy a half decent gas tool kit and essential label set, does anyone...
Please tell me the best place/s to buy plumbing fittings and tools?
cheers
Also, is there...
TECHNICAL SALES ADVISOR - TRADE COUNTER (LONDON)
perfect for a plumbing & heating engineer...
Can anyone recommend a good squeeze off tool upto 32mm?
I had to change a 3/4 inch rad valve today and the tail had 2 grooves instead of a hex key.
Is...
Where do u guys buy most of ur hand tools mine are startin to get batterd and a lot have went...
- ih1
- 2
- 2K
- Latest:
- plumben
Hi
Boss phoned me today and he asked me to take him a 25mm hole cutter to put in an adaptor to...
Got my van open and tools stolen on Friday. Hope these low life scambags will rot in hell. This...
Just gone through my power tool kit today got quite a bit
1x 12v dewalt drill
1x 18v dewalt...
Had a puncture this week I knew where the jack was in the back but took ages to find the...
- rpm
- 4
- 4K
- Latest:
- rpm
I've been told that there is available a tool that removes the Giannoni glands easily a bit like...
For anyone thinking of smaller cordless, Hilti now make them. £179 for complete kit I see...
Looking to purchase a battery press tool for various use. Looking at the following:
REMS accu...
This weekend in South of England
How to get here Finding the show by Car The FFX tool...
Hi guys I'm after a new reseating tool as my cheapo one has finally packed in.
Any...
- Thegift
- 3
- 2K
- Latest:
- chris watkins
I was thinking of having a permanent set up in the back of the van for recharging batteries as I...
- clarky_two
- 10
- 1K
- Latest:
- DrainMedic
Hi,
Ive just started my level 2 Guilds, already signed up for level 3 and then I'm hoping to...
Hi All
Here's a blinding deal if you use crimp-fit fittings, or would like to try them, but...
What is your opinion on Mutli tool sets I need to buy all new as I've just got a Makita 18v with...
This looks so handy, wondering if it would fit through uk full way isolation valves. But still...
I know this has come up loads before tried searching for it but I never get on with searching...
New Threads
-
Vaillant echTEC Plus 838H over pressurisingHello. Not to long ago I took off a radiator...
- Started by lee2lee
- Replies: 0
-
-
Issue replacing 22mm pipe on central heatingHi all I was hoping to make good this corner...
- Started by kristeva
- Replies: 4
-
-
Inspection chamber leakWould someone be able to advise please. I’ve...- Started by BobThomas
- Replies: 8
-
Aliddin easyfit isolator, Anyone with a bad experience of these?Hi all, thinking of fitting the said isolator...
- Started by Barry
- Replies: 2
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 2
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 1
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 9
-
-
Boss your bathroom - Join the Tile High ClubTrade Account Victorian Plumbing 10% off for...
- Started by Dan
- Replies: 0