bath | Page 4

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

bath

Recent contents Top users
  1. M

    Bath self drained overnight

    Long story short, filled new bath to silicone seal. Didn't touch pop up/click waste and noticed that 90% of the water has drained overnight. Is this normal or should these wastes block the water indefinitely? Thanks
  2. B

    Bath waste pipe install?

    I’ve removed a shower tray & have installed a bath. I’ve got the trap ready to go on but how do I go about connecting pipework up to this? Obviously I will unscrew that old shower waste off.
  3. K

    help identifying bath mixer taps

    Hi all, I'm having a lot of trouble trying to find replacement cartridges for this set of mixer taps. They were purchased approx 10 years ago. I have been told they are from ultra finishing, but they having looked at the pics state it's not one of theirs. Any help identifying them would be...
  4. B

    Which way bath rubber seal?

    I’ve got a McAlpine bath waste & it’s come with the two rubber seals one for the plug (which is the bigger one out of the two in pics) & the overflow. Which way around do I put them as the plug one has one side with loads of lines compared to the other side which has a slight dip with one line...
  5. Tinribs

    Removing Victorian tap handle (mixer tap) for bath

    Hi all, trying to replace a Victorian mixer tap head for bath as old one getting stiff. I've got cap off and taken screw out however can't remove handle (not budging at all!). Any advice?
  6. P

    Does anyone recognise this bath shower mixer

    Hello everyone I need to replace this bath/shower mixer but cannot find any identification marks on it . Does anyone recognise it please. I need to replace with something similar Many thanks Paul
  7. P

    Thermostatic mixer bath taps

    Just replaced taps on bath so kids can get a shower in bath as well ,worked fine to started with then water wasn't hot so took them back and exchanged them ,now these are doing same any ideas anybody ?
  8. C

    Poor flow of hot water in bath

    The hot & cold pipes to my bath are 15mm, shouldn't they be 21mm. The hot water is feed from a hot water tank and is a dribble whilst the cold is very strong. Should I have the pipes changed to 21mm or would an electric pump on the hot water feed suffice? If fitting a pump, are they robust and...
  9. W

    Bath or shower tray that’s 600mm wide max

    I’ve got to take out an old acrylic 600mm wide bath and replace it with either a similar sized one or a shower. Has anyone any source of either a bath that’s up to 600mm wide and under 1700mm long or a shower tray that’s 600mm wide and 1000-1500mm long. Really struggling to find anything...
  10. B

    Replacing shower with bath?

    I’m looking to replace this shower tray for a bath with the front of it facing the right side of the picture. What do I need so the bath waste goes into where the shower trays waste currently is now?
  11. D

    Sealing edge of bath - sealing tape

    Hi - need some assistance. What tape do you recommend when doing belt and braces approach to stop water ingress against wall and bath? I did see: Orion 10m Waterproof Sealing Tape on victoria plumbing. Thanks.
  12. M

    Bath/Shower Mixer has fine sand like grit flowing out

    The hot tap of a bath shower mixer has fine yellow sand like grit coming out, check all other taps in the house, this is the only one - combi boiler so no water tanks. Any ideas?
  13. T

    Can I fit a thermostatic valve to a bath/shower mixer tap?

    Hi, I'm having a new bathroom installed and having issues getting the right bath/shower set up. Shower has to be over bath as no space for a seperate one. We have kids who have baths and need it to be easy for them to rinse their hair during them. AT present we have a lovely Victorian style...
  14. T

    No hot water to bath taps. Everywhere else is fine.

    Hi everyone. We have installed a new shower kit (over the bath). Not touched the bath mixer taps (thermostatic mixer) other than to replace the old hose with a new hose. Ever since, we have not had hot water in the bath taps. Not even warm, just freezing cold. Is this going to be an expensive fix?
    • thenameisblonde
    • Thread
    • bath hot water taps water
    • Replies: 2
    • Forum: UK Plumbers Forums
  15. J

    Vado celcius 2 way divert bath filler pulsing output

    Vado celcius 2 way divert bath filler or shower, fed by salamander pump, water pressure and temperature to shower outlet works perfectly well, when diverted to the bath filler water output pulses. all input valves , cartridge and diverter valve replaced but issue still remains. Shower in ensuite...
  16. C

    Low water pressure in bath mixer tap for shower head?

    Hello - am hoping someone out there can offer some advice... I've been living in a split level 1st & 2nd floor masionette for two months, which was built in the 60's. Heating is provided via combi boiler. Water for kichen is fed straight from the mains supply (both hot and cold), however, we...
  17. I

    Leaking Bath Mixer Tap

    I'm probably missing something obvious, would welcome any suggestions on how I get access to the washers. We have a matching bathroom suite and the bathroom sink mixer was a breeze to fix. The top of the taps popped off easy enough and the "collars" could be removed to expose a nut to unscrew...
  18. M

    Quick question - bath mixer in shower?

    Looking at a particular range (Vernis) of Hansgrohe taps and mixers. A 2 function bath mixer seems readily available but can only find a 1 function shower mixer. I will have a shower head and a separate hand shower so wanted a 2 function setup so I can switch between the two. Can I use the...
  19. G

    What is this noise? Sometimes when shower, bath or toilet is running

    Hi, Just wondering if anyone knows what the cause of this noise might be? Sometimes it is a rumble but today it was this amazingly annoying squeak!
    • GC2
    • Thread
    • bath noise running shower toilet
    • Replies: 7
    • Forum: Boilers
  20. O

    Notching joists for 1” 1/2 waste bath/shower

    Guys I have read the labc advice on notching and I’m all ok, I have calculated a max 38mm notch allowed but that isn’t going to allow for my 1” 1/2 pvc.. what an earth do I do? Notch really needs to be 42mm deep Thanks!
Back
Top