gas fire | Page 9

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

gas fire

Recent contents Top users
  1. D

    back boiler gas fire unit b.b.u.

    when removing gas fire back boiler to replace,do away with back boiler and renew with a new fire,can the liner remain.
    • desrob
    • Thread
    • back boiler boiler fire gas engineer gas fire
    • Replies: 23
    • Forum: Boilers
  2. T

    Flueless gas fire min room size calculation, a little help please.

    Okay I am servicing a Burley esteem 4221 (lpg) this week and apparently it requires a min room size of 30cu3. evidently I am going to want to check this as part of the service. How do I check/calculate this? P.S yes I could go out to my van and get my gas book But I though Id ask here... and...
  3. N

    Gas Fire

    Hi all, Went to see a very sorry looking Grateglow Chimera ILFE gas fire. Pillow up the chimney, coals are non-existant etc etc. Can you still get parts for these does anyone know? Cheers
  4. T

    kinder oasis Inset Gas fire

    Got to service one of these tomorrow, got the oxy pilot ready. Have you guys got any advice that may save me a bit of time I haven't serviced one of these before. cheers
  5. D

    gas fire

    i did a job last week involving disconnecting a gas fire,the reason the customer requested this was because they applied for free wall insulation.they were refused because the employees of the wall insulation company said the gaS fire is dangerous because the flue is not pulling,i asked how he...
  6. D

    baxi baroque gas fire

    i have been back to this fire three times and each time the spark generator has failed,in my experience the spark generators do fail but there a robust bit of kit and this should not be happening,all electric checks ok,so at a bit of a loss,has anyone come across this before.
  7. W

    Which one gets your vote for the best high efficiency inset living flame gas fire

    Guys, Soon, I'm going to purchase this item here: FIREPLACE SURROUND IN PORTUGUESE LIMESTONE 54" ROKFD | eBay I'd like to set it off with a nice open living flame, high efficiency inset gas fire.I have a chimney. So my question is: In your opinion which is the very best High Efficiency gas...
  8. D

    gas fire back to coal

    is it the norm to use a chair brick to reduce the builders opening to accommodate a coal fire from a ilfe fire
  9. B

    gas fire

    got call off customer saying gas engineer had let them down can i call and fit a new fire - not much on so went today- they had bought an ilf fire i looked and the old fire was a baxi back boiler and fire not in use now as they got combi fitted 4 years ago. explained to them that they need a...
    • buckley plumb
    • Thread
    • fire gas engineer gas fire
    • Replies: 8
    • Forum: Gas Engineers Forum
  10. T

    Flue clearances- gas fire

    Hi, I have a room sealed natural draught flue that needs to be installed vertically from the fire, terminating on a new flat roof extension, does anyone know what the clearance should be from the flue to an openable window, also does the flue need to rise above pitched roof line? The fire is...
    • Tom1980
    • Thread
    • fire flue gas engineer gas fire
    • Replies: 8
    • Forum: Gas Engineers Forum
  11. S

    Gas fire installation - are these upfront payments reasonable?

    I'm on the verge of accepting a quote for installation of a hole in the wall gas fire, new flue liner, associated plastering, removal of rubbish etc. The (small) company has requested 50% deposit (that's over £800), then an 'intermim payment' of another 25% followed by the final payment on...
    • spantik
    • Thread
    • fire gas engineer gas fire installation
    • Replies: 23
    • Forum: Gas Engineers Forum
  12. S

    Shared Class One chimney/flue (?) & hole in the wall gas fire installation

    I am getting to learn a lot about fitting an Atina HE 'hole in the wall' BFM Kinder gas fire but I need more HELP please? I have talked to lots of installers (Gas Safe registered) about this job but I'd be glad of your opinions on one particular issue - the flue? I live in a modern (1978)...
    • spantik
    • Thread
    • fire flue gas engineer gas fire installation wall
    • Replies: 17
    • Forum: Gas Engineers Forum
  13. M

    Flueless gas fire

    Alright lads, First time iv been asked to install a flue less gas fire, so im a little sceptic! Iv made sure the 100cm2 of free ventilation is in place, the room size is adequate, there is an openable window, the wall its installed on is fine, there are no other vents closer than 500mm! Iv...
    • mcniven
    • Thread
    • fire gas engineer gas fire
    • Replies: 18
    • Forum: Gas Engineers Forum
  14. G

    Advice on gas fire fitting please

    Hi all, have been asked to fit a Stovax Stockton 5 gas stove. Don't normally fit gas fires as a rule but this is for a lad i know. I have followed the MI's and fit a 5" flue liner already, ordered the fire and the adaptor from the steel flue to the liner, there is a lad there boarding all the...
  15. C

    Victorian Tiled Insert With High Efficiency Gas Fire

    I'm looking for a Victorian Tiled Insert with a High Efficiency Gas Fire probably will have to be glass fronted All my searches lead me to lead me to a CastTec Integra 5kW in 4kW out ( www.casttec.co.uk ) Dose anybody know of other manufactures of this type of fire or had experience of...
  16. L

    lpg gas fire info

    Hi, I'm over from the electrical forum. I live in a area where there isn't mains gas, I want a lpg gas fire in my lounge. My house is old church I converted a few years ago so there is no chimney and 950mm external stone walls. I can't find a LPG fire with a horizontal flue with his longer...
    • llywelyn111
    • Thread
    • fire gas engineer gas fire
    • Replies: 2
    • Forum: Gas Engineers Forum
  17. P

    Gas fire pipework

    Can someone clarify the rules and stipulations of the pipework requirements to an inset gas fire, I cannot find any reference to it in my BPEC gas safety book. I understand that pipework should be wrapped in the opening prior to entering through the casing and sleeved through a wall, but I...
    • purpleorange
    • Thread
    • fire gas engineer gas fire pipework
    • Replies: 13
    • Forum: Gas Engineers Forum
  18. D

    gas fire's

    what would you class, not been able to access the builders opening when doing a landlords cert on a gas fire,i'm sick of fires been glued,sealed into position,i have to date just been noting it on cp 12,but unsure if i should be doing more ....?
  19. J

    Cannon Precept gas fire manual

    Hi Does anyone know where i can get hold of a copy of the manual for a Cannon Precept gas fire. I've searched the internet without success. I am wanting to know the height and width openings of the fire into the builders opening. Thanks
  20. P

    Flavel Raglan Balanced Flue Gas Fire

    Help, my son has a fairly recent one of the above and when his local GSR engineer came to do the annual service one of the FOUR allen screws which hold the glass front in place (which is, also of course, a seal) just turn when trying to screw it out (or indeed, in) which indicates that the...
    • PowerFlusher2
    • Thread
    • fire flue gas engineer gas fire
    • Replies: 1
    • Forum: Gas Engineers Forum
Back
Top