Think I know the answer is no but asking just in case. I have a solvent weld bathroom waste with lots of connectors in it that disappears into the wall with a right angle connector. There is no place to break into it to connect up a new arrangement for a new sink. So does anyone make a...
As part of a slow DIY bathroom refit I've removed the old toilet from the original location next to the soil pipe (and obviously capped off the branch) and plan to place it the opposite end of the room. I was pretty lucky to find a 110mm sewer waste pipe below the old sink which is the new...
Hi All,
I'm plumbing in a washing machine into our new house and rather than a normal waste pipe this house just has a hole in the ground. It looks as if the hole used to be a 40mm pipe but it has been sawn off at ground level such that the top of the pipe is flush with the floor tiles. This...
I have bought a shower tray and it has an extra large hole for the waste trap. Its a cooke and lewis think its an eclips 1400 x 900 tray. The hole is 160mm and has a lip around it for the cap at 200mm. Cant seem to find one in the correct size, hope someone can help.
small hole in plastic waste pipe which is the better fix ?
Hi there need some advice please, i have drilled a small hole in the plastic waste pipe which serves the sink & shower in the loft when doing some work in the toilet underneath on the ceiling i have cut away the plasterboard to reveal...
Hi,
I need some advice connecting my bowl sink to the waste. There was a Insinkerator installed that I have replaced with basket strainer waste (Viva PP0011).
I need to connect the waste but I find myself going around in circles in regards to selecting the correct parts.
Thanks
FrankW
Hi all
Do any of you guys use a silicone to seal between the bath and waste rubber underneath?
The bath is only a cheap one and the bottom of the waste opening isn’t flat, which seems to leave an opening enabling water to leak out.
I used silicone in the past for this very problem but I was...
Hi,
came across this old push fit waste pipe. Stripped out the old shower and it was a 40mm waste pipe siliconed in the fitting.
The fittings at floor level so I’d be looking to bend (90 degrees) straight away so I can get the lowest possible shower tray.
Could someone advise what I could...
Evening all. Not sure if this is the most appropriate place to post this in the forum, happy to move if not.
I'm looking for a metallic 32mm matt black waste pipe, to match up with a matt back trap. The pipe that comes with the trap is 400mm, which isn't long enough for my installation. I'd...
A while ago I replaced a leaky, corroded sink trap. That all appears to be fine, I can't find any leaks with it, and everything under the sink appears to be consistently dry.
The problem I have is that there appears to be a leak where the waste pipe out from the bottle trap meets the wall...
2 years ago next door turned into a hmo and couple months later we got backlog of raw sewage coming up from drain.
We phoned jet wash guy and he came did a really good job strange that a rubber duck came out and no one in the house had rubber duck.
Also few month's ago we went out and came...
Good afternoon, please see my attached diagrams
One is the current layout
And one is where I propose to add another boss to add a shower waste.
This horizontal run is below floorboards but I can't get to the TEE or under the tee to add a boss vertically.
( the current Bath is bossed way in...
Afternoon, our bath waste pipe in our rented property has started leaking slightly when we shower. We've narrowed it down to a loose screw in the centre of the plughole. My understanding is that this screw being loose means that water is able to leak out between the bath waste and the waste...
New house and smells comes from shower... It's a merlyn shower waste it's not like your usual design.
I've lifted up the chrome but or I'm I suppose to lift up the other bit to get the hair bucket removal out? This design I don't see where the seal is to stop smells through?? Any experience...
Good day,
Can someone please advise me if it is possible to replace old terracotta waste pipes for PVC in a section only?
My sewage line goes downhill away from the house to the sewer main. What I assume to be an inspection shaft is at the bottom of my property.
I want to replace only a...
Anyone know if theres somewhere in the uk that stocks a water diverting valve to fit 32mm waste pipe?
Something similar to this where you can choose to send the water down the drain or divert it to somwhere else. (garden flower beds in my case)
just put a new pop up waste into my basin to find the trap does not fit correctly..
the trap fits just inside the waste thread opening and butts up against the plastic shoulder ensuring the rubber seal is pressed against the end Face of the waste.
im able to screw the nut up but even when its...
Hi, just hoping someone can advise on best option to connect 40mm waste pipe to a flexible bath waste hose of approx 30mm, I assume some form a spigot to will needed but not sure exactly what to search for.
Many thanks in advance!
Hi Folks, I want to connect a bath waste outlet to a hose, but I'm struggling to configure it. It's for a temporary rainwater collection system that's being installed on a remote farm. I need to get from the plughole to a connector that will fit a hose. But I keep drawing a blank, but I'm...
Hi, I have just moved the washing machine into the garage and it will not drain.
I wonder if it's something to do with the way I have installed the waste?
The washing machine is only a month old and was working fine this morning before re-positioned.
I put an 1100mm hoorizontal run at around...