Morning All,
Just after some advice as I have been asked to plumb in a sink and washing machine waste for a new kitchenette. The other side of the stud wall shown is the bathroom, with the toilet attached to the soil pipe bottom right and a small basin attached to the 32mm waste. The wall is...
I currently have a floor standing pan in a downstairs cloakroom. The waste is vertical about 10mm on the inside of a 2- brick external wall.
As I'm completely retiling the room, can I fit a connector that runs horizontally behind the current waste below floor level( by cutting off some of the...
Hi all,
I'm in the process of fitting my freestanding bath. The supplied waste chrome pipe that runs into the floor is an unusual diameter - 38mm (European?). The bath came with a PVC multi-fit coupler to connect this chrome pipe to standard plastic waste pipe but its to long once I get under...
Hi all,
I'm currently in the middle of first fixing the waste pipe for my freestanding bath. I've created a mock version out of plastic to determine where the waste enters down through the floor - see photo.
I was just wondering is there any minimum length the pipe has to run after the trap...
Renovating an upstairs bathroom. Void between floor boards and ceiling below is too narrow to hide the waste pipe from a wall hanging toilet.
My plan is to build stud wall with sufficient width to hide the 100mm toilet waste pipe into the existing stack. In practice this means extending the...
I'm looking to install my new washing machine.
The waste pipe was clipped round the back of the machine during transit. It popped out of some of the clips with ease, but one clip seems sealed.
I need the extra length, so ideally need to unclip it from the clip shown in the photos below. Is...
Hi
I’m trying to find something that will connect a geberit 90mm toilet waste pipe into a standard 110mm soil stack. The geberit cistern came with an adaptor that increased the outside diameter of the pipe to 110mm. However this is the same diameter as the soil stack pipe. Is anyone aware of...
Hi
The toliet pipes attched to the Macerator started to leak water yesterday when flushed. The macerator made a longer than noirmal whirring noise too. None of the waters been flushed and waste has come into the bowl with water, right to the top.
I've ordered a water pump vacuum from amazon...
Hi, please can you advise
The sink in the kitchen has started becoming blocked and the sink keeps filling up. I have poked things down it to try and make the water go down and the sink drain became completely unscrewed. Is this possible to become unscrewed this way ? And how do I stop this...
Hi
I fitted a bath/shower 12 years ago and a few months ago it developed a leak.
It was basically at a coupler on 40mm solvent where my new white PVC joined the existing grey PVC.
I cut a hole in the ceiling and could also easily view it with the bath panel off but not access it from there...
Hi
Looking to 'crowd-source' some public opinion on this one.
I bought a studio apartment on 30th September 2022 and I'm currently working with contractors to refurbish it. I'm 39 and it is my only property (I'm no property tycoon).
Next door's bathroom is on the other side of the wall to my...
Hi!
(Please see the attached terribly technical drawing of my layout!)
I'd like to know how I may route the waste pipe from my vanity.
The waste pipe from the bath runs along the back wall of my bathroom, above the floorboards to an outside exit point (also above floorboard level). The old...
Morning All
After some advise on repairing a sink waste that goes into the toilet pan, which goes straight into soil stack.
Had bathroom done 2 years ago, and then needed a new basin waste fitted recently.
Plumber who fitted basin waste discovered a bodge from previous bathroom fitter, where...
Hi,
Noticed a leak in my sink and the pipe collapsed down for the P trap. So I was going to replace it all. However, i've been stuck because this starting part from the sink isn't forming a good water tight seal. The rest of the pipes kind of insert into each other nicel and have a grove in the...
Does anyone know of any adaptor you can use to fit the waste of these into an appliance trap? Cannot seem to find anything online. There is one but pretty bad reviews.
Thanks
Morning all,
A diy'er here. I'm installing a new kitchen in a room on the opposite side of the house and need run the sink and dishwasher waste under the floor to the opposite side and go out where the existing kitchen is, around 9m. The driveway and garage are outside the wall in the new...
I need to connect a 1"½ kitchen waste pipe to a drain but it will have to go at a slight uphill.
I have never had to deal with this before and I like advice on what best to use and model. I am aware that a macerator pump can be used?
any help welcome t. T
Hi folks,
Got a cracking deal on a stone resin shower tray but unfortunely it hits the joist slightly.
The joist is around 3.25" wide and 6.75" tall, and I would have to cut out a vertical notch from the joist of 1.15" (at the max, it will probably be less than this) for it to fit.
Would...
Hi guys after a bit of advice ....
An old close coupled pan will be replaced with a new close coupled pan.
With the waste line been quite far from the wall, the old one was attached to the waste using a really long flexi pan connector , bent at an awkward angle backwards then up through the...
I’ve removed a shower tray & have installed a bath. I’ve got the trap ready to go on but how do I go about connecting pipework up to this? Obviously I will unscrew that old shower waste off.