Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the Showers and Wetrooms Advice - Whether a tiled sealed shower using a tray former and tanking, to create a wet-room. Or even just plumbing in an electric shower or shower using jets or mixer taps. Ask a plumbing question in here..
Normal Threads
Hi all. Any idea on the best way to repair this quite visible chip around the shower tap...
- banesto72
- 4
- 936
- Latest:
- king of pipes
Hey all,
Let me just say I will probably get a plumber in to do this, but I just wanted to...
- mattydart
- 3
- 855
- Latest:
- ShaunCorbs
I have an open vent CH system with two cold water tanks in the attic.
The hot water cylinder...
Hello. I'm hoping for some advice, please. I am having a new bathroom installed with a walk-in...
I have just sorted out a new landing page on my web site for visitors from Plumbers Forums. This...
- Alan Wright
- 11
- 3K
- Latest:
- centralheatking
Hi, need some advice please. Getting new bathroom fitted. Plumber has fitted my new stone resin...
Hi Guys, I have just removed an unused shower from my house and have exposed the water pipe as...
- TonyG
- 3
- 1K
- Latest:
- king of pipes
I need some help please. I am looking for a shower drain cover for this drain. I dont know...
- Moh2020
- 3
- 891
- Latest:
- Stigster
Evening all, hope this is in the right forum.
I’ve got a triton bar mixer shower which is...
Evening all,
I have had a leak in my shower, which after an investigation looks like it's may...
Hi everyone
I have the following shower to fit. It has a three way valve.
The diagram shows...
Hi - I have bought a Grohe thermostatic shower to fit to my main bathroom. I have a gravity fed...
- superflo
- 5
- 2K
- Latest:
- shyguy2005
Hi
Can somebody please help me with a problem I have. This has appeared recently on the ceiling...
Hi. We have recently had a Mira Atom EV Thermostatic Bar Mixer Shower Valve & Kit installed...
- LynnD
- 2
- 3K
- Latest:
- Dan
Could anybody advise me whether an electric shower can be installed from the rising cold water...
Hi Everyone,
Customer has worcester 38cdi that keeps going up to 4bar pressure, i replaced the...
- plumb_know
- 5
- 125
- Latest:
- plumb_know
Has no manufacturer markings at all. Thanks.
- pictone
- 5
- 2K
- Latest:
- pictone
I have a Baxi Duotec 2 40 GA Combi boiler 8yrs old and Hudson Reed Exposed Shower. Recent...
- Steve2401
- 12
- 4K
- Latest:
- ShaunCorbs
Hi all
Some advice if possible.
I fitted a new shower yesterday (Mira ERD Realm) thermostatic...
Hi. Does anyone know of other manufacturers of a Venturi boosters shower other than the Trevi?
I...
- Dicky drain off
- 2
- 2K
- Latest:
- Alan Wright
Guys , apart from showerdoc ( I never have any luck with them ) can anybody recommend any other...
- townfanjon
- 8
- 1K
- Latest:
- townfanjon
So I was asked to go look at a job today I was told 3 plumbers have been at previously with the...
Hi everyone...hoping someone can help with the ongoing issue.
long story short, shower (non...
so long story short...
old shower going hot and cold
new shower installed
new shower going and...
Hi, just taken over a bungalow that has a conventional water cylinder downstairs, vented to a...
A drain pipe was installed many years ago with the incorrect slope so it was recommended that I...
morning,
I can’t get the right fall for my shower waste and I’m in top floor flat. Can anyone...
- Gogg89
- 5
- 1K
- Latest:
- centralheatking
Hi I have just moved into a bungalow and it has a Aqualisa mixer conceal shower in a tarnished...
I've read previous posts about loss of signal during showers, but i think my problem might be...
I've a customer who's keen on a combi to replace their existing regular boiler and copper...
New Threads
-
-
Vaillant echTEC Plus 838H over pressurisingHello. Not to long ago I took off a radiator...
- Started by lee2lee
- Replies: 0
-
-
Issue replacing 22mm pipe on central heatingHi all I was hoping to make good this corner...
- Started by kristeva
- Replies: 4
-
-
Inspection chamber leakWould someone be able to advise please. I’ve...- Started by BobThomas
- Replies: 8
-
Aliddin easyfit isolator, Anyone with a bad experience of these?Hi all, thinking of fitting the said isolator...
- Started by Barry
- Replies: 2
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 2
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 1
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 9
-