Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the Plumbing Jobs | The Job-board - .
Normal Threads
Hello, I’m after a bit of advice regarding a radiator that warms up but only gets approx 60% as...
Hi, can any one give any advice on UFH please? We have a system that goes through one pump...
- Rich123
- 1
- 750
- Latest:
- AWheating
A month or so ago I asked on here about the pros and cons of press fitting and I said that I'd...
- Deleted member 96286
- 7
- 11K
- Latest:
- Jim Goodenough
Hi guys , Not gas related just wondering if there is a better way or an app to this site rather...
- Matt0167
- 2
- 120
- Latest:
- Harvest Fields
- Locked
Start-up Bangs & shut-down pops AFTER service.
Potterton Boiler C50/15 (circa 1972?)
Our...
- GasAt300Bar
- 15
- 346
- Latest:
- GasAt300Bar
Hi, oil ran out in June, got it refilled last week. I noticed the Afriso de-aerator did not fill...
- nocturnal
- 13
- 13K
- Latest:
- Best
Concealed cistern, this one has pan fan and is operated by IR button if that makes any...
I have an issue with a Ideal logic 35kw boiler and system pressure.
Boiler was over pressuring...
I'm being lazy as I'm sure MIs tell me somewhere.
Doing an install with an unvented cylinder...
- finchy01
- 2
- 109
- Latest:
- ShaunCorbs
Hi guys/gals, my Baxi runs fine if cold set pressure is no more than 0.5bar, pressure increase...
- quietman
- 16
- 2K
- Latest:
- Rob Foster
Hi, I’m renovating my house and a completely new plumbing system is being installed. New combi...
Hi, the last radiator in the line has stopped heating up! All the others are nice and hot and...
Hi
I have a manifold with 7 zones. All are working as they should apart from one which is for...
Evening all,
Where would one source one of these, are they available?
Thanks
- Sharp Point
- 20
- 224
- Latest:
- ShaunCorbs
Hello all
1st post so be gentle
when i moved into the property we had 5 single and 1 double...
Hello everybody.
I am just about to install an unvented cylinder. 2 heating zones, one hot...
- dan_the_plumber
- 3
- 847
- Latest:
- ShaunCorbs
Afternoon all,
I'm at a lose with a radiator problem that I'm hoping someone may be able to...
Thermal fuse blown in the above boiler. No part number for it as it Comes complete with the hex...
- ISM
- 2
- 93
- Latest:
- Last Plumber
Hello folks
I haven't had any experience working on radiators when it comes to replacing them...
- Marty1979
- 4
- 4K
- Latest:
- Marty1979
I have it on my kitchen mixer (hot side only) but it's never bothered me so never looked into it...
- WaterTight
- 6
- 122
- Latest:
- WaterTight
Hi, I've installed a 2 zone kit that uses an RWC mixing valve, Thermomix with hot in, return to...
Guys,
I am just changing my own heating system to a sealed system (not the hot water, just...
Looking for some guidance please.
I have above boiler, its the 35 store, been in 6 years and now...
Since drain and refill of our gravity fed system I cannot get heat to alot of the downstairs...
- michael fearn
- 9
- 2K
- Latest:
- michael fearn
Hi everyone. I'm hoping somebody will be able to offer some advice. I've recently moved home and...
I used to pay £130 a year and it creeps up and now its £165, I'm getting a little bit sick of it...
- Phil
- 6
- 112
- Latest:
- Phil
Hi
I'm in the process of getting a multifuel boiler stove installed. The stove will be heating...
- Byersb18c
- 3
- 3K
- Latest:
- chris watkins
Hi all new member here, due to sit ACS in January currently portfolio building, always looking...
- Garry bunting
- 4
- 980
- Latest:
- Tony
hi any ideas would be greatly received
leave stat set on timer - when boiler comes on rads...
Hi,
Was hoping to get some advice... When I moved in the central heating was not working (they...
New Threads
-
-
Vaillant echTEC Plus 838H over pressurisingHello. Not to long ago I took off a radiator...
- Started by lee2lee
- Replies: 0
-
-
Issue replacing 22mm pipe on central heatingHi all I was hoping to make good this corner...
- Started by kristeva
- Replies: 4
-
-
Inspection chamber leakWould someone be able to advise please. I’ve...- Started by BobThomas
- Replies: 8
-
Aliddin easyfit isolator, Anyone with a bad experience of these?Hi all, thinking of fitting the said isolator...
- Started by Barry
- Replies: 2
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 2
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 1
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 10
-