baxi | Page 9

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

baxi

  1. G

    Baxi Duo tec 2 straight swap needed.

    Can any of you fine folks tell me which Baxi/Potterton/Main boiler would be a straight swap out for a 28Kw Duo Tec 2 GA Combi please. I dont do many boiler changes but have been co-erced into doing this one. If I can get a boiler that would fit in its place without altering any pipework would...
  2. A

    Baxi Solo 2 change recommendations.

    Hello everyone. Another post to add to the endless list. I have been asked to go and give a price for replacing a Baxi Solo 2. The customer has said that he has already been quoted for a 30kw boiler. It's a y plan set up with open vent. He said he might also decide on an unvented cylinder...
  3. B

    Baxi boiler needs topping up daily

    Hi, we've got a Baxi Combi 105 HE boiler which is about 13 years old. It needs water adding every time I put it on as it keeps dropping 0. I was going to nurse it through another winter but I'm thinking things must be dire now. How much would a like for like replacement be with fitting, a...
  4. G

    Baxi Combi 80 fault

    Hi there I was called out tonight, no heating no h/w. Pump would run, pump proving made (continuity across connections at board), no power to fan across L-N, but getting 240v L-E. Going back tomorrow with the PCB but just wanted to confirm this diagnosis. The fan resistance was 30.6 ohms which...
  5. J

    Baxi Bermuda PW5 Gas Fire Problem

    Hi all, i have the above gas fire with back boiler. The boiler is working fine but there is a problem with the fire after first light of the cold season(cold according to my wife). The ignition has always been tempramentel so we have always used a "clicker" gas igniter. We press the knob down...
  6. S

    Baxi 800 (with EvoHome)

    Hi everyone Newcomer here and freely admit to not knowing much about central heating or even plumbing in general tbh! I've got an old (20+ years) combi at the moment that is on its last legs (hot water is intermittent plus various faults over last 18 months). Consequently I'm looking to replace...
  7. A

    Baxi 105e issue

    Hi all, Just a quick one to tax your tired brain cells. Got a customer with one of these old beasts & i was called out to it late evening because of flashing 30 & 50 degree lights & no heating/hot water. Had a quick look at it and nothing obvious bar an occasional drip from the diverter valve...
  8. king of pipes

    Baxi net- tec 28 - 325 fault code ?

    Called out to this fault supposedly a low voltage problem , replaced the pcb now sorted .kop
  9. ShaunCorbs

    Baxi cash back

    . Cough cough ;) . .
  10. hammers4spanner

    Baxi tech help

    Anyone finding this has gone to cock , waited 20 mins on the phone to get some grumoy idiot who was yawning and seemed to have no interest in helping. I phoned them up couple months ago on warranty call back and got same attitude very poor now
  11. king of pipes

    Baxi 412 heat only

    First full strip down on this fitted 24 months ago now customers bills have come down significantly so all's good , could do with 3 hands on one of these but no dramas in the end .kop
  12. U

    Baxi boiler regular resetting

    Hi my old Baxi boiler, regularly serviced, keeps cuttng out and needs reset. Happens about every week.now.. Pressure is absolutely fine. Mentioned it to engineer at its service 4 weeks ago and he could find nothing obvious, but it had only happened once at that point. Once reset all seems...
  13. Dame1701-

    Refill a Baxi combi boiler (24 series)

    Hi guys, We have a baxi combination boiler which needs to be re-pressurised (error code 119 I believe). I've done this several times on different boilers using the tap on the front. I just want to confirm that we need to turn the two taps at the front to repressurise. From what I understand we...
  14. ShaunCorbs

    Baxi Discontinuing

    Atm Baxi duotech Baxi platinum Baxi mega flow Start of October but this is depending on stock
  15. E

    Baxi Titanium vs Baxi Platinum

    Hello, I have been quoted £2200 for a Baxi Titanium and £2600 for a Baxi Platinum combi install. As far as I know both have stainless steel heat exchangers. The only difference seems to be the warranty - seven years vs ten - is this correct or are there other differences I should be aware of ?
  16. Luke78

    Hot water temperature problem Baxi 105 HE

    Hello again all: Firstly: Personal background, as I know people are likely to ask: 1) I AM GSR 2) Most of my work so far since qualification has been on pipework, fires and cookers with the odd boiler service. 3) At the advice of other members I have made arrangements to go on the Baxi...
  17. shaky

    Baxi Service engineer

    evening does anyone work as a service engineer at Baxi? If so what’s it like? you can PM if you like Cheers
  18. I

    Baxi sales representative

    I'm meeting up with the local baxi sales rep tomo9, having recently signed up to baxi products. Mainly for their new heat only boilers. My question is, what one off freebies can I get out of this rep...money off boilers, baxi merchandise etc etc... Seems like a sound chap having met him on...
  19. king of pipes

    Baxi 600 range of combis

    Finally got round to fitting one of these today Halstead ace out and Baxi 630 in , first impressions is not good, no jig ,new filling link is a faf to fit and s- ite design, commissioning it is a ball ache 7 minutes purge cycle not a lot of good when the fur kin pump is siezed grrr , so...
  20. M

    Problem with burned baffle Baxi Solo

    Hi Folks, Thanks for allowing me to join the forum. I have some engineering knowledge but would not touch a gas boiler! I have a maintenance contract and the engineer came to check my Baxi Solo 2 PF for its annual service / inspection. On opening up there were lots of tutting noises. As I was...
Back
Top