I have a Baxi Burnall open fire with wrap round back boiler connected via a Dunsley Baker Neutaliser to the vented hot water tank.
I wish to update my older vented system to an unvented twin coil indirect water tank with two immersion slots. I want to use one immersion slot for my recently...
Hi everyone. I've just joined this forum as I'm desperately in need of some help. My elderly parents (81 and 77) have a Baxi Solo 3 pf60 and it has been giving trouble. I'm not a plumber but a process operator for a chemical manufacturer and an experienced DIYer, so I'm obviously limited with...
Hi!
So I have just moved into a new house and it has the above boiler fitted and I am trying to understand it as best as possible.
The control is set to water and central heating, Normally there is a temperature control for the central heating and then one for the water, but this is combined...
Hi there, bit of a hot water issue (or more lack of it) ever since I installed a new bathroom a few months ago. When the hot water tap is fully open the boiler heats the water as normal but intermittently the gas cuts out for 10-15 secs until the water cools back to 60 degs and then fires up...
Leaking Overflow from Baxi DuoTec Combi 28 HE A. Is it a faulty PRV ?
Pressure gauge is showing zero so no central heating or hot water. When I try to re-pressurise by opening the fill valve, the gauge will only rise to just over one bar and the CH will then work. BUT... all the water rushes...
Hi there, couple of questions.
1. Is the hive smart thermostat compatible with a baxi 200.combi boiler?
2. Is the hive smart thermostat compatible with the baxi duo tec 24?
3. In terms of quality and performance what are the differences between the baxi 200 and duo tec?
4. What is the best...
Just installed this and Runs like a dream when going, but when it has been off and cooled down it keeps coming up error code 109 pre circulation fault. Thought maybe air in system and after a few false starts fired up and away it went. Job done, home. Call the next day about the same error code...
Hi all ,
just looking for a little bit of help with this if possible. My boiler is showing low pressure and after watching countless videos and reading other threads I’m still stuck on what I should be touching or if I’m missing a fill pipe and that’s why or whether the taps are there and I...
Went out to one of these today no hot water heating is ok was fitted 2016 on a clean system, couldn't get a repair cartridge so changed the whole 3way assembly block and motor didn't sort it to my surprise ???? Sits in heating mode and doesn't switch over to hotwater although the motors working...
Hi all. After experiencing issues with luke warm hot water and reading about the relative simplicity of refurbishing the diverter valve in the Baxi 105 he I went ahead and did the job (with some trepidation)
To my relief the boiler is now working much better, however it is also leaking a fair...
I have an intermittent high pitched whine on a boiler of just over 2 years old (which I think is the pump).
I can't seem to find a direct replacement and in any event is there another better alternative ?
The central heating on my Baxi DuoTec Combi 28 HE A has stopped working but the hot water is fine. I have also discovered a leak from somewhere on the lower isolation valve to the Fernox TF1 Compact filter, it may just need tightening up. I'm guessing that it could be the diverter valve but...
Hello all and thanks for letting me post this question in your forum.
I have just had a quote in of £5,700 to replace our old baxi bermuda back boiler with a new baxi 800 combi boiler. All pipework in the property would be changed and along with nine radiators. Decommision and remove the old...
Just installed a baxi 228 2 weeks ago flushed the system out as there was a fair amount of sludge ,boiler was running fine but now the ch pipes below are banging occasionally but kept them up throughout the night ,the boiler doesn’t even have to get to temperature on the heating .ive tried the...
Went to a Baxi duo Tec 24kw today plate heat exchanger was choked up with debris really bad and no hotwater , did my usual trip to the local car wash and power washed it out cost me £4 mind as took 2 goes , serviced the boiler and the expansion vessel recharged repaired a leak on the sensor all...
Hi guys any of you lot familiar with these ,
Not firing for hot water at all doesn't even try, had the call brought a hot water flow sensor as it was only pennies saved going back to merchants , no joy ... heating works fine.
Can some one explain to me how the sensor works ( on a blue tab...