burner | Page 3

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

burner

Recent contents Top users
  1. M

    Glow Worm burner cycling on Pmax when trying to gas rate

    Hi I am gas safe registered, when commissioning glow worm Ultimate 3. Have put into p.01 to gas rate and set at Pmax, but burner keeps cycling on and off rather than running at full rate, so am getting incorrect gas rate, any thoughts?
  2. O

    Oil burner locking out

    Hi All, I recently ran out of heating oil and consequently the Riello burner locked out. Once I was refuelled I bled the oil supply to the burner and after several attempts to reset, it kicked in, albeit with a whirring noise on startup. It has run for 3 days and I had noticed the whirring noise...
  3. H

    Riello Burner Replacement Model No. & Reillo Fitter (London Area)

    Looking to replace our RIELLO 40 FS10 (3758435) Gas burner - 0.13kW, FAM.OIK.2 =12 -100mbar (42-116kW) but can no longer see the availability of this particular burner. Looks like it has a newer model that may have superseded it. Am I right in saying the replacement would be the RIELLO 40 GS10...
  4. R

    Does my gas cooker burner need replacing

    Hi, I have 15 year old Cannon Caniston gas cooker and when I turn the tap for the biggest burner full on it burns as if it was only half on, this has happened over time. I have checked the flexible hose is not kinked and the gas at the main is fully on, the other burners seem to be ok. I cleaned...
  5. H

    Gas Valve - Inlet Test Point and Burner Test Point screws

    Hello, Some advise please. Doing my gas course so I have taken a few boilers home to practise taking them apart so I can understand more how they work. For the gas valve in a Worcester boiler I got my hands on I have been trying to undo the screws for the Inlet test point and Burner test...
  6. H

    New burner smelling

    Hi guys, I had to replace my oil burner, it was a Worcester bosch. The burner house is outside but I have noticed the new burner is stinking the house when running, mostly my son's room which is above the burner house... Is this normal and will it clear or do I need to get the engineer back who...
  7. Alan Wright

    Fitting a Back Boiler To A Wood Burner

    I want to fit a back boiler into my Ecoburn Plus 11 KW WoodBurner and feed heated water to my radiators. I need advise and perhaps someone to fit the back boiler.
    • Alan Wright
    • Thread
    • back boiler boiler burner fitting
    • Replies: 3
    • Forum: Boilers
  8. F

    Motor bearing size required for old style electro oil burner

    I attended a lock out on a 40 year old Myson with an electro oil burner.Old style with orange fan housing.End dog was destroyed due to worn bearings.I replaced both bearings but one was the smaller type.Unfortunately i used my last one and forget the size as i need to order more. Not very common...
  9. B

    Oil Burner Control Box - What is wrong with it?

    Hi I have a Riello RDB2 and it gets power, tries to fire but no spark or flame and the red light on the push button comes back on. Smoke comes out of the control box. There is a fire valve over the burner and the plastic cover was off the burner, the fire valve leaked and oil leaked onto the...
  10. P

    Burner replacement keston

    Our Keston k60 recently had a minor problem but was nearly written off as the gasket was almost impossible to find. Luckily as I am retired and so had time to search the country and get the engineer to come back once it was in hand. So I decided to collect a range of spares to ensure we dont...
  11. V

    Need diagram for combining wood burner,hw storage tank, ufh

    Hello everyone, I'm new to this forum, and I need advice, and a good schematic for combining a lot of components, so they will work the best. So here are the main components: 30kw wood burner 1000 litres hot water storage tank 200 litres DHW storage tank with 2 serpentines (one will be used for...
  12. D

    Oil fired boiler burner shuts down after running normally for five minutes.

    Hi, I'm having problems with my oil fired central heating boiler. Its a Panda II with an Electro Oil burner fitted with a Danfoss oil pump. The problem- The burner fires up normally as per, and the flame is well established, however after seven minutes it flames out and then locks out after the...
    • Dave W.
    • Thread
    • boiler burner running
    • Replies: 4
    • Forum: Boilers
  13. C

    Camray 5 oil burner warning lights meaning

    Need help deciphring these lights on a camray 5 oil burner. What do they mean ? I can't get the flow to heat up the water storage cylinder . The motorized valve won't open . Any ideas or suggestions on the subject ? 1588106893
  14. P

    Stuck Riello RDB burner

    Relatively new to servicing, but have come across a Riello RDB unit that will not disengage from the unit. I have unbolted the securing nut but the burner will not budge. the boiler is a Warmflow unit quite a few years old and from the look of it and the oil hose I have replaced, not been...
  15. G

    Riello RDB Burner Photocell Sooting Up

    I have a Riello RDB Burner housed within a Grant Outdoor module 70/90. During the last 2 months the boiler has stopped firing up at about 3 week intervals and I have had to clean the photocell in order to rectify the problem. I had the boiler serviced last summer.
  16. S

    Riello RDB burner lockout (Firebird combi)

    Hi all, The burner keeps locking out on my boiler with increasing frequency to the point it can be every few minutes. So I thought it was locking out when working but it's seems it gets up to temperature shuts off and this can happen the first time or any number of times. Quiet buzzing Louder...
  17. F

    Reduce the power of gas burner by lowering the motor rpm

    Hey guys ! We have a big industrial boiler (installed to provide heating for 80 apartments) which comes with a natural gas burner. The burner has a 4KW 3000RPM motor which provides the air flow to the burner, is it possible to replace the motor with a 1500RPM motor to reduce the heat output of...
  18. Inverness

    Firebird oylympic 50/70 old style riello burner

    Nightmare.. Hi guys need advice. Went to service a friends boiler that hasn't been service in years... He has cleaned out the heat exchanger from time to time but that's all. The boiler was working fine. So I started out cleaning the heat exchanger which was clean.. the replaced a new nozzel...
  19. R

    New Riello burner issues

    Hi, I recently fitted a new Riello RDB2.2 E21/26 to replace my old burner of 16 years. It worked first time no problem but every time I want to use the heating now I need to go out to the burner/boiler house to press the little reset button on the thermostat box. It is firebird 70/90 and the...
  20. M

    Worcester Greenstar 28i no green ‘burner on indicator light’ flashing diagnostic light

    Last night our combo boiler got turned off at the mains all night. We noticed this morning when we were all getting ready and plugged it back in. There was no hot water or central heating, the pressure gauge had dropped way into the red, and the burner indicator light no longer came on green. We...
Back
Top