Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the General DIY Plumbing Forum - Ask DIY related questions in this forum.
Normal Threads
Third time I'll be doing this floor...first time was weatherproof TnG, 2nd was marine ply both...
Background
I have a small one-bedroom flat in the roof space in a victorian house. There are...
- Kevan C
- 3
- 861
- Latest:
- ShaunCorbs
Hi,
I would like to connect up water supply to fridge.
Behind the fridge there is 15mm...
- rafal_22
- 2
- 704
- Latest:
- Basher
A while ago I replaced a leaky, corroded sink trap. That all appears to be fine, I can't find...
- Ben B London
- 2
- 827
- Latest:
- ShaunCorbs
Hi all,
My partner and I recently bought a house and have been attempting to make the bathroom...
Hi All
I hope you are doing well.
I have this water tank for hot water heated by a Baxi boiler...
- JohnMalcolm
- 1
- 483
- Latest:
- Chuck
We had a blocked outside drain .Got the same guy out again to unblock . Sewage is coming through...
Hi - I’d like to replace my single old 1 sump pump with a combination unit, primary and backup...
I need to change my scalemaster magnetic scale inhibitor as it is leaking but I cannot work out...
- kirstyrevels
- 1
- 705
- Latest:
- exedon2
Newish house with radiators that have microbore pipe but on one of them the pipe is sticking up...
- boyo119
- 7
- 864
- Latest:
- ShaunCorbs
Hi All,
I hope you are doing well.
I have this 3.25mm lead-free grade 99c solder wire. I know...
hi all,
I'm just sorting the drainage for my freestanding bath. Due to a slight misalignment of...
Hi All. I am trying to locate the stopcock in my property. After a good few hours searching I...
- GMH1966
- 3
- 715
- Latest:
- GMH1966
Hi there,
Please excuse my lack of knowledge on this, my plumbing knowledge is very limited...
Hi, I need a small water heater for a bathroom sink tap.
I was going to have an unvented...
- kevins
- 4
- 808
- Latest:
- ShaunCorbs
Hi I have a little problem or a question if all you experienced people can put me straight...
I have a factory lagged indirect hot water cylinder in the airing cupboard, installed about...
Good morning
I installed a Harvey’s water softener recently. Have a semi detached property...
- aa1986
- 1
- 758
- Latest:
- ShaunCorbs
Hi all, just removed a radiator while decorating. One side was easy, the other just spun round...
- Rilla
- 11
- 1K
- Latest:
- Rilla
Help! I'm in a bit of a panic and need advice. Our kitchen outside drain is blocked and nothing...
Hello
I am desperate for some help. Basically we are having our bathroom renovated. The plumber...
Hi I’m looking to install the above. Atm I have an older one fitted (old wireless thermostat and...
- Glasgowman
- 4
- 836
- Latest:
- Glasgowman
Is it possible to change a lever flush handle for a push button one using same cistern? If so...
I'm in Canada, where the standard is NPT. I just put in a heat pump and shut off the hand valves...
- imaddicted2u
- 0
- 676
- Latest:
- imaddicted2u
Struggled with an element that was far too wide to come out of the aperture (how was it ever put...
Fitting a vertical rad after having hallway replastered and after a bit of digging about online...
- Liam6200
- 2
- 838
- Latest:
- Liam6200
Hi, the immersion tank is running all the time and we can't switch it off. I've uploaded...
Hi guys, I have a question regarding converting an open vent system (copper cylinder) to...
Hi, I have a dishwasher that needs to move further back to fit flush with the other units, as is...
Plumbers Talk
New Threads
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 1
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 0
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 9
-
-
Boss your bathroom - Join the Tile High ClubTrade Account Victorian Plumbing 10% off for...- Started by Dan
- Replies: 0
-
Mixer Tap Cartridge change advise.Hi Our kitchen mixer tap is leaking around...
- Started by Eejay
- Replies: 1
-
What plumbing tape is recommended for a copper waste water pipeHi there, We have a leaking waste water pipe...
- Started by Tellie
- Replies: 2
-
Programmable digital cylinder statI bought one of these: and I am using it to...- Started by siricosm
- Replies: 9
-
Heatrae Sadia multipoint 50 issue?Hi folks I’ve never installed or maintained...
- Started by macka09
- Replies: 3
-
Is this bend in a PEX pipe too much?Hi, I by chance discovered that amongst a...
- Started by techweb
- Replies: 5
-