Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws
Questions and plumbing advice in the General DIY Plumbing Forum - Ask DIY related questions in this forum.
Normal Threads
Good morning I have a Adey's magnaclean filter fitted onto the flow pipe ,and when i had it...
- CHRISTOPHER2023
- 4
- 847
- Latest:
- Uins
Last summer I used one of those kits to fit an external tap , all went well , still good , its...
Hello. I've attached an image of an old garden tap with a new garden tap replacement, except the...
Im looking to install a saniflo or similar, with the outlet rising up through a flat roof and...
- Marc Bowers
- 18
- 2K
- Latest:
- Chuck
Does anyone know where I can get a DCV with an isolator that is WRAS approved?
I need one for...
- Triumph1
- 2
- 794
- Latest:
- Marc Bowers
Hi Guys,
Wonder if someone can help?
It's a new installation, I turned the water on for the...
Hi.
I have to replace the taps on a small sink. Currently the tails fit onto the hot and...
Hello
I have ran my washing machine through the autoclean - i have added special detergent like...
- Trac
- 1
- 774
- Latest:
- SimonG
We were painting my friends flat that he is renting.
We used b and m gloss paint on skating...
- shocksl
- 1
- 576
- Latest:
- snowhead
Just moved into a house and I was going to install a new shower. I went to turn off the water on...
Hi, Not sure if its the right forum, please feel free to move if not.
Went out to a leak on an...
I have purchased a thermal camera as my valliant engineer has stated that there is a leak in the...
Hi
I am new to this forum so forgive me if I add this to the wrong place.
I have purchased a 2...
- lukeL81
- 6
- 1K
- Latest:
- lukeL81
Hi, the Lux 6L needs 1bar pressure in the manual, but I want to gravity feed it from the hot...
- Melbro2
- 0
- 646
- Latest:
- Melbro2
Hi- In an apartment and the attached picture is what I have. I am looking to install a magnetic...
- delaneybob
- 4
- 871
- Latest:
- delaneybob
Hi All,
Could use some valued help redoing a stack to accommodate a washer and utility sink...
Hi Folks, I need a bit of advice or help.
I have a low pressure hot water system due to the Hot...
- Jagobezzer
- 2
- 768
- Latest:
- John.g
I am tiling a shower wall and need to drill holes for 15mm pipes that will go to a thermostatic...
I've installed an AAV on my washing machine drain line, but even with it, it seems to still be...
- sunkentreasure
- 3
- 849
- Latest:
- sunkentreasure
The discharge hose from our washing machine comes out of the machine, runs about five feet along...
Noise seems to stop when softener is bypassed, not 100% certain. Noise is intermittent, a...
- Sarafailsbetter
- 0
- 756
- Latest:
- Sarafailsbetter
I have a caravan with a brand new heating system.The Valliant combi boiler is working fine but...
Hi, is the below pictures the right setup for my nest heat link to my Worcester greenstar boiler...
Hi, We‘be recently moved into a property with a very old Potterton statesman. My husband bled...
- Ruth Mullen
- 4
- 1K
- Latest:
- Ric2013
Hi All! first post. 👍
Im starting to put together a plan to put two bathrooms in my house. I'm...
- MrBird77
- 1
- 812
- Latest:
- Charlotte22
Has anyone seen tap heads like these? Trawled the internet cannot find anything similar, after...
Hi People,
So, I'm looking to fit a new Monarch Midi HE water softener, upstairs bathroom...
I now have a Main 18 HEAT ERP boiler which has its own bypass valve. Should I remove the...
Can anyone advise me on a possible flexible connection between a water inlet pipe and a cistern...
- Bp89
- 8
- 952
- Latest:
- Bp89
Hi,
I have noticed the hot water faucet under the kitchen sink is leaking. It seems to be...
Plumbers Talk
New Threads
-
Ultra compact wall hung toilet frameI'm redoing our 4' x 4' downstairs loo. My...
- Started by UserError
- Replies: 1
-
-
So... Does anyone know what this is??As I said, any ideas what this is for? It was...
- Started by Jonnyfrance
- Replies: 5
-
Potterton Promax 15 HEBeen called out to an issue with a Potterton...
- Started by MethodPH
- Replies: 3
-
Best flush cones for low level cistern connections?Any recommendations other than the usual clear...
- Started by macka09
- Replies: 4
-
-
customer wants boiler in unheated storeroomunheated storeroom, with louvre doors open to...
- Started by Gasinspect
- Replies: 1
-
Seized Filling Loop TapHi, any ideas on how I can get this seized tap...
- Started by fadsarmy
- Replies: 1
-
Non-return rat flap/blocker at drain exitHi folks! I have a question re rat flaps /...
- Started by Johnfella
- Replies: 0
-
Texture metal lined pipe?Hi guys Any of you use the above pipe at all...
- Started by macka09
- Replies: 4
-
Rusted screw removal tool??Hi guys any advice on removing rusted screws...
- Started by macka09
- Replies: 0
-
An Boiler be left on with water tuned off?I have a Worcester Greenstar boiler and would...
- Started by Traveller 47
- Replies: 9
-
-
Boss your bathroom - Join the Tile High ClubTrade Account Victorian Plumbing 10% off for...- Started by Dan
- Replies: 0
-
Mixer Tap Cartridge change advise.Hi Our kitchen mixer tap is leaking around...
- Started by Eejay
- Replies: 1
-
What plumbing tape is recommended for a copper waste water pipeHi there, We have a leaking waste water pipe...
- Started by Tellie
- Replies: 2
-
Programmable digital cylinder statI bought one of these: and I am using it to...- Started by siricosm
- Replies: 9
-
Heatrae Sadia multipoint 50 issue?Hi folks I’ve never installed or maintained...
- Started by macka09
- Replies: 3
-
Is this bend in a PEX pipe too much?Hi, I by chance discovered that amongst a...
- Started by techweb
- Replies: 5
-