Plumbing Jobs | The Job-board | Pro & DIY - | Page 46 | - Plumbing Advice Forum > PlumbersForums.net

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

Questions and plumbing advice in the Plumbing Jobs | The Job-board - .
Normal Threads
when the customer says I have OCD I will hang the radiators. She then calls to say it is ready...
Replies
10
Views
221
I have a job at a b&b that the water is apparently getting scalding. It has an old oil boiler...
Replies
5
Views
2K
Hi, what do people a think is the best way to add a secondary return to an unvented cylinder...
2
Replies
29
Views
492
Evening all, I’m looking to do a make over to our future home, I was thinking of UFH downstairs...
Replies
13
Views
184
hi - my kitchen overflow is leaking and I’ve discovered the connection has come loose but there...
Replies
3
Views
3K
    • Like
    • Agree
Hi engineers Just a heads up that we are currently offering the ADEY magnaclean professional...
Replies
0
Views
1K
So the cws in the attic needs to be moved a few metres. Is it ok to run the vent pipe across...
Replies
1
Views
1K
    • Like
Gas installer event...it’s like a massive plumbers merchants but nothing has a price on. If you...
Replies
12
Views
2K
Bought this discontinued bath and freestanding bath taps from Wickes. The taps were quite...
Replies
7
Views
2K
anyone used these from toolstation they seem very cheap???
Replies
10
Views
73
Hello, I've just had my sink unclogged and my tap heads replaced and the total cost of this was...
Replies
15
Views
3K
Murdoch
M
Has anyone tried to clean a partially blocked secondary heat exchanger using system chemicals...
Replies
2
Views
86
A
Is anyone familiar with the Jet Range isolation valve DN20 which is operated by screwdriver...
2
Replies
34
Views
4K
Hi. Looking for some hopefully very simply advice. I needed to replace a side entry flush valve...
Replies
6
Views
2K
Looking at ordering a few sets of benders, I’ve always used Rothenberger ones. Are they much of...
2 3
Replies
54
Views
6K
Hi I had to take the plinth boards off in the kitchen to install a new oven and at the back I...
Replies
7
Views
2K
A
Hi - got an aqualec UFH system with aqualec thermostats in each room displaying the temp, with a...
Replies
1
Views
1K
Evening guys, IGEM/UP/10 does anyone have a virtual copy or link from which I can download...
  • DXCross
  • 5
  • 122
  • Latest:
  • Sharp Point
Replies
5
Views
122
Sharp Point
S
Hello Guys Help needed again problem on the above boiler. Hot water works fine however the...
2 3
Replies
70
Views
1K
Hello, Im replacing the mix valve on my boilermate system, do I need to drain the hot water...
Replies
5
Views
2K
I had a debate with an electrician about correct wiring of regular Worcester boilers. I told him...
Replies
9
Views
129
Hi Everyone, Does anyone know if the heater exchange (0020025264) from a Valliant Glow Worm...
Replies
4
Views
964
hi all, Can anyone explain why my hot and cold water pipes in the cupboard under the kitchen...
Replies
13
Views
10K
I've removed a radiator from the wall. The trv and lockshield are still attached to the pipes...
2
Replies
33
Views
9K
  • Locked
went out to a customer and found the pub burnt out. It’s an old ultimate 30ff. Found the...
Replies
13
Views
3K
O
Hi Lads, I am selling A Flir C2 camera which is in perfect working order. As I am going to...
  • Old Account
  • 2
  • 104
  • Latest:
  • Old Account
Replies
2
Views
104
Old Account
O
Anyone familiar with alphas? Not worked on one before. I had one a couple of days ago that had...
Replies
3
Views
110
I recently power flushed with an acidic solution on a particularly dirty system. I drained and...
Replies
7
Views
129
Hi guys. I'm going to put my washing machine adjacent to my bathroom. The path of least...
2
Replies
27
Views
4K
Post a New Thread / Question

New Threads

Back
Top