logic | Page 5

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

logic

Recent contents Top users
  1. R

    Ideal Logic + Combi "Flame loss post Stabilisation" error after Smart Meter installation

    Hi all, First off, I'm just a homeowner looking for advice, I'm not a gas engineer. On Friday I had smart meters installed and 5 times since then (never previously), the 3-year-old Ideal Logic + Combi boiler has made a fairly loud humming/vibrating noise while running hot water for a few...
  2. G

    Isar to Logic direct straight swap?

    Can anyone tell me if the new Logic boilers are a direct replacement for an Isar? Due to quite tight spacings, Im looking for a straight swapout if possible. G.
  3. J

    LPG Training by Logic

    So I have just returned from training at Worcester HQ, doing the LPG training and assessment, now its not Worcesters fault but when I was answering the questions I couldn't find the answers in the book anywhere, I am very methodical in looking in the index, going to correct sections and tracking...
  4. A

    Ideal logic flame loss

    Thanks shaun
  5. J

    Cost to replace ideal logic 24+ sump

    Hi all, I have been informed my boiler sump on my ideal logic 24+ has a crack. A common fault on the ideals by the looks of it. I can source the sump for about 55 quid. How much would you say is reasonable to replace the part. Ps I've just had my boilers serviced and they never noticed the rust...
  6. C

    Ideal Logic Heat 15 - F/A Code

    Hi I wonder if anyone can help with a central heating issue. I have a 7 year old house with Ideal Logic Heat 15 Boiler - this runs central heating and hot water system. Over the past few months I notice the boiler running then cutting out and restarting quite a lot, after 15 minutes of doing...
  7. J

    Ideal logic + combi 30

    Hello Guys Help needed again problem on the above boiler. Hot water works fine however the heating comes on temp on display goes to 70-80 and the boiler turns off. None of the flow or return valves get hot although the main heat exchanger does. DV motor operates, even with the motor...
  8. J

    Heating engineer advice - Ideal Logic combi - isolated heating and pressure issues.

    Please would any heating experts advise what damage the heating engineer could have caused to our boiler. He isolated the boiler, turning off valves to the heating so that he could decide whether the ongoing pressure drop (0.5 bar a week drop) was within the boiler itself, or whether a pipe in...
  9. P

    Programmable room thermostat for ideal logic

    hi guys. After recommendations for a programmable room thermostat. Preferably wired and if possibly weather compensation. It is going on a older model ideal logic combi.
  10. P

    Best programmable room thermostat for old idea logic

    hi guys. Customer is after a good programmable room stat for an old ideal logic. Preferably wired and preferably able to have weather compensation aswell. Thanks guys.
  11. S

    Ideal logic main heat exchangers

    Why are these still leaking on recent boilers. Had a call today from a new customer to look at one of his renters, for frequent pressure loss. He had a logic plus 35 installed in 2017( not by me). I whipped the cover off and the trap had the usual white floating fog, consistent with the...
  12. R

    Logic Plus 35kw - Regular low pressure warnings

    Hi all, any help appreciated. Had a Logic Plus 35kw combi installed in early 2016. All working great until recently. Late Nov last year, we got the following error; 'Low Water Pressure - 1 fill system to 1.0 bar - 2 bleed rads - 3 contact installer' Good news is filling the system worked and...
  13. D

    Ideal Logic 30 kW or Vaillant ecoTEC plus 430?

    Hi all I am getting my central heating system revamped as per of a house renovation project. 3 bedroom house with zonal heating system, including underfloor heating in new extension, with radiators elsewhere. I'll be putting a 30 kW, gas fired, heat only boiler in (without solar thermal), and...
  14. D

    Logic Combi 24 Receiver Problem

    Hi. I have a logic combi 24 with Salus RTF500RF thermostat. The thermostat box itself is working fine and connecting with the receiver. However the receiver is not connecting with the boiler to turn the heating on. The light comes on the receiver to show that the signal comes in, but the...
  15. Z

    Looking for a mentor to complete ACS Logic Gas

    Hey guys! I’m looking for a mentor to help me complete my ACS Logic Gas Portfolio Willing to work hard and travel; have access to a car I’m located in Slough, Berkshire! If anyone could help me I’ll grately appreciate it Name : Zed Contact Via pm Thank you If you have any questions please...
  16. A

    Ideal Logic Combi Flame Loss problem edited - advice needed

    My boiler Ideal Logic 30 Combi shows flame loss error (F2 fault). Boiler is in the newly property and so far has been used just for hot water, which worked fine. The problem appeared when I tried to switch on central heating (The CH system has been drained, flashed and refilled).With "C" on the...
  17. A

    Ideal Logic Combi Flame Loss problem - advice needed

    Hi! I bought a house with a boiler installed Ideal Logic 30 Combi. I don't have warranty on it, although it's rather new, of 2015. The whole system has been drained flashed and resealed. When I moved in I was just using hot water. When I switched on CH mode, boilers makes a noise before...
  18. S

    Ideal Logic & Logic + firing in the night?

    Apologies if this is a daft question! I've not worked on many Ideal's normally Worcestershire & Baxi's. Is it normal for the Ideal Logic & Logic + models to fire intermittently throughout the night even when no demand? Thanks in advance Spreck.
  19. V

    Ideal Logic 35 Boiler Losing pressure *Solved*

    Evening All I used this forum over the last month to research my problem with the Logic 35 boiler losing pressure. Background - My 4 year old boiler began losing pressure at around 0.3-0.5 bar every day about 4 weeks ago. Like any worried home owner i checked the following things: 1. PRV - tied...
    • Vik
    • Thread
    • boiler ideal ideal logic logic pressure
    • Replies: 8
    • Forum: Boilers
  20. A

    Ideal logic l2 fault

    Hi I have just had a friend of a friend message saying her boiler doesn't work. From what she is saying it's displaying L2. I'm reluctant to race round there right now as she wants a quote to repair so unlikely she will want to pay a fee for me going on a Sunday evening. She has an immersion...
Back
Top