Sok it to me ********s!! | Plumbing Jobs | The Job-board | Page 5 | Plumbers Forums

Welcome to the forum. Although you can post in any forum, the USA forum is here in case of local regs or laws

  • Thread starter Kyle87
  • Start date
  • Replies 132
  • Views 2K

Discuss Sok it to me ********s!! in the Plumbing Jobs | The Job-board area at Plumbers Forums

Status
Not open for further replies.
4e9aju6y.jpg


Thought had already uploaded this one.
 
i dare anybody else to up a photo, go on your all quick on the keyboards.:yes:


Thats because most are keyboard warriors. Well done to anyone who has posted a picture for all to see and cast an eye over. Shame on those that have past judgement without
 
and the burn and missing plaster where there when I started, honest :)
 
never had an issue with them yet, so can't comment on their unreliability, as with all kit, it's normally installer error that is the issue.
 
Other than the udderly ridiculous condense trap and the jig at the bottom, they're no worse than a DuoTec.
 
condensate !!! trap, doesnt have any washer or cap that can leak, which is a bonus in my mind and the jig could be better, but I prefer to use robo kits where possible to avoid the need for a jig at all, or if needed use the jig case to run pipes up the rear if needed.
 
Not gonna work with gas capped? Bit of a basic fault? But a spirotec? Crossovers look tidy. Would have run hot round under flow parallel to gas and tied it in higher up and fitted a doc .
 
Photo0041.jpg I have upped this before. tis a solid fuel/gas boiler/thermal store combo. the laddomat valve and quencher are next to the wood burner. btw the flue is running up behind a stud frame and accessible.
 
Status
Not open for further replies.

Similar plumbing topics

Don't think that M.valves will pull in air...
Replies
17
Views
4K
As a young man i installed a lot of one pipe...
Replies
25
Views
7K
  • Locked
Oh dear, I pity the poor installer that didn't...
Replies
15
Views
13K
  • Locked
Yes, thanks - was thinking something along...
Replies
11
Views
2K
This thread is over 3 years old but it would...
2 3
Replies
61
Views
23K
Back
Top